DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Windows and Doors > sliding barn door suspended in air




Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 06-19-2012, 05:08 PM  
FiveTenMatt
Junior Member
 
Join Date: Jun 2012
Posts: 4
Default sliding barn door suspended in air

Hey Everyone!
This is my first post! My fiance and I just bought a new 2 bed 2 bath loft. It's amazing, but has one small drawback: it has no door separating the master bedroom from the rest of the loft. To complicate things, while one side of the "doorway" is a wall, the other side is a window, which means hanging a traditional door won't work very well. To make matters worse, the "doorway" goes all the way up to the 17ft ceilings, and there's a giant HVAC tube that runs through the space. I've attached a picture of the space to help you visualize what I'm talking about.

So, we're contemplating installing a sliding barn door that will go part way up the 17ft (basically, up to the HVAC), closing off the area visually. The issue I'm having is how to do this in a structurally sound manner. The wall to the right of the doorway is exactly 3'1", and the door way is slightly under 4' wide. I don't see this as a problem though, because we'd like to have the door extend slightly over the wall when closed, so that it can be closed from either side of the room.

So, my specific questions are these:
1) Do folks think having the rail for a sliding door that extends into the air would be a possibility?
2) If the answer to #1 is yes, How should we do this in a structurally sound manner? Would mounting the rail on the 3'1" wall be sufficient to hold up a solid wood door? Should we drop a cable from the ceiling to help support the overhung section?
3) How should we stabilize the door to keep it from swinging without a bottom rail? Could we have a shorter rail on the bottom that would only be used for this purpose?

Any other thoughts or suggestions on how to close this space economically and aesthetically? We're not dead-set on the sliding door, it just sounded like a neat idea. Thanks ahead of time for all your thoughts!



missing-door.jpg  
__________________

Last edited by FiveTenMatt; 06-19-2012 at 05:11 PM.
FiveTenMatt is offline  
 
Reply With Quote Quick reply to this message
Old 06-19-2012, 05:49 PM  
nealtw
Contractor
 
Join Date: Nov 2010
Location: vancouver, b.c.
Posts: 9,707
Liked 791 Times on 706 Posts
Likes Given: 1354

Default

Welcome to the site and congrats on the new digs.
This is the kind of thing, where you get a different answer every time you look at it.
When we divide up office space we often have walls that just stop at a window sill and I think that might be an answer here. I would look at building the wall in floor to ceiling and and leave a standard 32x81 opening for a 30" door. You could build it thicker to allow a pocket door and that would need higher rough framing. The plug on this wall wiould be another problem.
I think others will be along with more ideas



__________________
nealtw is offline  
 
Reply With Quote Quick reply to this message
Old 06-19-2012, 05:56 PM  
FiveTenMatt
Junior Member
 
Join Date: Jun 2012
Posts: 4
Default

Thanks nealtw! Correct me if I'm wrong, but it sounds like you're suggesting I build the wall in around the space to enclose a traditional door. I don't think I'm interested in building a new section of wall entirely. I like having the open loft feel, and a sliding door that doesn't go all the way to the ceiling would maintain that feel. I'm hoping to build it out of reclaimed lumber to give it an old look that matches the old warehouse feel of the condo. If we can accomplish this, I'd like to show off the door, and not hide it in a pocket. You mentioned the wall outlet... Good point. I'm planning on moving that outlet regardless of how we manage the door, so I'd say disregard it.

__________________
FiveTenMatt is offline  
 
Reply With Quote Quick reply to this message
Old 06-19-2012, 06:27 PM  
nealtw
Contractor
 
Join Date: Nov 2010
Location: vancouver, b.c.
Posts: 9,707
Liked 791 Times on 706 Posts
Likes Given: 1354

Default

Well then, with the step down at the door I would guess the we are looking at a bearing wall, and not steel studs. If so then you could bolt up something heavy duty like 4x6 timber or a 4x4 angle iron and hang the door off of that.
Old warehouse doors have a small wheel on each side of the door bolted to the floor which would be just infront of the old wall

barn-door.jpg  
__________________
nealtw is offline  
 
Reply With Quote Quick reply to this message
Old 06-19-2012, 06:36 PM  
FiveTenMatt
Junior Member
 
Join Date: Jun 2012
Posts: 4
Default

Yeah! That's along the lines of what I had in mind, except the bit over the doorway isn't connected to anything. Do you think a cross beam would be necessary, or do you think that the rod that the door is suspended from would be substantial enough to hold the door up on its own? The only reason I ask is that we have limited space, and installing a 4x6 beam would either require some revisions to the wall, or would make the doorway stand out substantially. What about attaching a cable from ceiling to the free end of the rod instead of adding a cross beam for support? Do you think that has any hope structurally?

__________________
FiveTenMatt is offline  
 
Reply With Quote Quick reply to this message
Old 06-19-2012, 07:22 PM  
nealtw
Contractor
 
Join Date: Nov 2010
Location: vancouver, b.c.
Posts: 9,707
Liked 791 Times on 706 Posts
Likes Given: 1354

Default

Cable would help carry the weight but would not give you anything for in and out stability. The standard hardware will not be strong enough as it is designed for bolt every so many inches. I think you should by figuring out the weight of the door and then talk to some iron works shop for help on the design of the upper support.



__________________
nealtw is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
sliding door leak greenlabel Windows and Doors 3 04-21-2011 02:18 PM
Bathroom barn door disaster! kch1983 Windows and Doors 8 05-21-2010 07:02 PM
sliding door leak joa629 Windows and Doors 2 09-17-2009 10:28 PM
condensation in sliding glass door WalterSobcheck Windows and Doors 17 08-05-2006 09:51 PM
Replacing a sliding glass door Outbacker General Home Improvement Discussion 1 06-06-2006 02:16 PM