DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Insulation and Radiant Barriers > Garage Roof Insulation




Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 10-07-2011, 10:20 AM  
corbins
Junior Member
 
Join Date: Oct 2011
Location: Littleton, Colorado
Posts: 7
Default Garage Roof Insulation

I would like to insulate my 2 car garage. I use the the ceiling to store wood so I want to leave the ceiling open. I would like to insulate between the top cord of the roof. The trusses are only made with a 2X4 so I don't have much depth. The roof is asphalt shingles and I don't have a ridge vent just soffit vents. I'm in Denver, Colorado so the temps can range from 0-100 degrees. I've been researching radiant or reflective insulation and solid foam insulation panels. What would be the best, easiest way to do this for a DIY. I know I won't get much of an R factor but think anything would help during the winters. Thank you.



__________________
corbins is offline  
 
Reply With Quote Quick reply to this message
Old 10-08-2011, 09:00 PM  
BridgeMan
Senior Member
 
BridgeMan's Avatar
 
Join Date: Aug 2011
Location: Cottage Grove, Oregon
Posts: 738
Liked 75 Times on 67 Posts

Default

Quote:
Originally Posted by corbins View Post
I would like to insulate my 2 car garage. I use the the ceiling to store wood so I want to leave the ceiling open. . . . . . I'm in Denver, Colorado so the temps can range from 0-100 degrees. . . . .
I don't like to dampen your enthusiasm, but looking at the big picture makes me wonder:

1. Spending winter in a Denver garage (doing woodwork) with no ceiling is not logical. Numb fingers or having to wear gloves will hinder precise woodworking, and any temporary heat will quickly float upwards into the attic area (but it will keep your stored wood toasty).

2. Why not sheetrock the ceiling, lay in some heavy (R31) batts above the sheetrock, and keep the supplemental heat in the work space?

3. Beneath the ceiling, you can build a few innovative lumber racks in locations that aren't being used (above the garage door comes to mind, or where the hood of your vehicles are when parked). Suspend the verticals from the trusses' panel points before rocking, connected to both top and bottom chords. If you're going to put hundreds of pounds on any one rack, consider tying each vertical to adjacent trusses on either side, using horizontal 2 x 4 spreaders. If you want to go heavier yet, have an engineer design some bottom chord flitch plates for you, glued and screwed to each loaded truss, in addition to the spreaders.

4. I've built at least a half dozen such racks in garages, and every one has worked extremely well. Just know their limitations, and keep in mind they are not to be used for hoisting engines.

5. You really need to install some venting at or near the ridge, in an effort to move attic air. Soffit vents by themselves are next to worthless, especially in the summer.
__________________
BridgeMan is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Garage Insulation jdb4whlr28 Insulation and Radiant Barriers 9 04-13-2011 12:56 PM
r20 insulation with 2x4 studs in Garage cmarlo Framing and Foundation 2 04-08-2011 06:29 AM
Roof Insulation Advice dancestudio Insulation and Radiant Barriers 4 03-04-2011 03:55 PM
A hip roof without soffits or insulation cittyguy Roofing and Siding 0 05-26-2009 05:01 PM
Garage insulation dlenardu General Home Improvement Discussion 1 11-21-2008 04:14 PM