DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Insulation and Radiant Barriers > Insulation options




Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 02-24-2013, 10:52 PM  
pfrost
Junior Member
 
Join Date: Feb 2013
Posts: 2
Default Insulation options

Anyone who can comment on my DIY Project it would be much appreciated. I am also considering making my home a passive house. Going to take a while with many stages:

Current stage of progress:
Existing House: 3 level split with carport. built 1962 NORTH VA

First level: Basement with thrid level above it and second level next to it. 8" block Below Grade to 4" block with brick veneer OG. Finished, but no insulated.

second Level: Living/ktch/din/carport over dirt crawl. Brick N Block to stick. Fiberglass Insulation in stick portion

Third Level: Beds n bath Stick c/ almn siding. Fiberglass Insulation.

Addition: On second level. 18" crawl over old concrete patio/carport. Pressure treated floor joyce by code.
Inspections passed: foundation, framing, plumbing and elect.
Unfinished: Siding, mechanical, drywall, flooring.

Addition is L shaped with an open floor plan. Carport closed in and wraps around the back. Back wall of existing to come out someday. LVL header & knee wall in place. Dried in with OSB & TYVEC.

The new roof extends from the existing ridge line over the old roof, making the thermal boundary difficult to pic. Considering removing old roof sheathing to make it easier to create the boundary, but not sure if it is necessary.

Attics: All are connected, but step up with a knee wall b/w 2nd & 3rd level with stair hall in the middle. Existing attic's are fiberglass insulated.

I have had a home energy audit with blower door test. Waiting for the results.

Now for the questions:
Are my following plans the best options for Insulating at each stage and which should be done first?

Starting bottom up:
1. Finished basement: Really don't want to tear up the basement at this point, but I think it is the place to start.
Plan:
a. Slow rise closed cell foam b/w block and finished wood panelling/drywall in bedroom.
b. Closed Cell Spray foam in band/floor joyce along perimeters only. Need to remove sections of ceiling to access.
2. Crawl spaces:
a. Dirt Crawl existing: No french drain or sump. It is dry in terms of good grading on exterior.
Install a vapor barrier from Clean Space encapsulation with closed cell spray foam from band joyce down and over vapor barrier onto the floor, only on the one exterior block wall. Will turn the corners a few feet for thermal contact or whatever they call that third law. Addition crawl surrounds old dirt crawl. Only one wall in old crawl is on the exterior.
Do I need a mechanical system in the crawl. I recall reading something about an inducer, maybe for humidity?
b. Addition slab Crawl: Same treatment, with vapor barrier wrapped around footers and all three walls. Closed cell foam.

3. Existing walls: I plan on residing and removing old cardboard sheathing.
Option 1: tape, caulk, or can spray foam joints and follow with tight packed cellulose.
Option 2: Closed cell spray foam$$$$$
Option 3: keep old fiberglass and seal tight with ridgid foam board and tape. Furring strips for screen then siding.

4. Addition walls:
Option 1: Closed cell sp. Foam
Option 2: seal gaps with caulk, tape, or canned foam and tight packed cellulose

5. Attic: Floor or ceiling?
A. Floor: closed cell spray foam or blown cellulose with soffit and ridge vents. Seal all joints and chases with canned foam or tape.
B. Ceiling:
1. Vented soffit/ridge with baffles and closed cell sprayed foam.
2. Vented with Ridged radiant barrier foam board facing roof and fastened to the top chord/joyce. Air tighten by taping joints or canned foam.

6. Any thoughts on “Foam it Green” and doing the spray foam yourself. I have read all the warnings about temp control and temp's during application process. I think I can still do it. It's still expensive though. Can I get the same energy savings/ R factor without the spray foam?



__________________
pfrost is offline  
 
Reply With Quote Quick reply to this message
Old 02-25-2013, 12:16 AM  
nealtw
Senior Member
 
Join Date: Nov 2010
Location: vancouver, b.c.
Posts: 8,945
Liked 677 Times on 606 Posts
Likes Given: 1200

Default

Welcome to the site.
Basement; Before doing anything, check condition of perimeter drain and the exterior waterproofing on the foundation are 50 years old. Build a 2x4 wall 1" away from the concrete with poly under the bottom plate and insulate this wall and the floor outside this wall with vapour barrier behind the drywall.
Crawl space, Others may say to seal it but I am a non believer. Sooner or later, a roof will leak or plumbing breaks or toilets overflow or what have you, you will get water in the crawl space. I believe you are far better off to insulate the floor and have good ventulation below. And again consider the perimeter drains.
Existing walls. If you have fibreglass and vapour barrier on the inside you do need gaps in the outside sheeting behind the housewrap. Housewrap stop water and wind from intering but allows water vapour out.
The old roof under new roof should have some hole to allow air movement from soffets to ridge.



__________________
nealtw is offline  
 
Reply With Quote Quick reply to this message
Old 06-16-2013, 07:25 AM  
WindowsonWashington
Junior Member
 
WindowsonWashington's Avatar
 
Join Date: May 2013
Location: Washington, DC, Virginia
Posts: 198
Liked 19 Times on 18 Posts
Likes Given: 28

Default

Karl,

Quite a few points of bad information in that link.

__________________
WindowsonWashington is offline  
 
Reply With Quote Quick reply to this message
Old 06-16-2013, 05:46 PM  
inspectorD
Housebroken
HRT_MODERATOR.png
 
inspectorD's Avatar
 
Join Date: Dec 2005
Location: Litchfield, CT
Posts: 3,934
Liked 94 Times on 81 Posts
Likes Given: 189

Default yup

Quote:
Originally Posted by WindowsonWashington View Post
Karl,

Quite a few points of bad information in that link.
Say goodbye to the spam...we eat good around here.
__________________

Just My
Made in the

inspectorD is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Adding insulation to a finished wall w/some existing insulation jimmiejames Insulation and Radiant Barriers 4 01-15-2012 07:31 AM
Attic Insulation/Baffolds/Wall Insulation/Air Leaks pkay Insulation and Radiant Barriers 3 10-23-2011 12:42 PM
What are my options? debraanne General Home Improvement Discussion 24 04-14-2011 12:30 PM
So Many Options Unregistered Decks & Patios 10 12-31-2010 01:37 AM
Is foam insulation or radiant barrier inas good or better than fiberglass insulation? MrsTopkat General Home Improvement Discussion 2 12-01-2005 08:11 AM