DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Insulation and Radiant Barriers > Vapour barrier over drywall?




Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 09-23-2013, 12:24 PM  
Jungle
Senior Member
 
Join Date: May 2013
Posts: 236
Liked 21 Times on 18 Posts
Likes Given: 20

Default Vapour barrier over drywall?

Up on the high ceiling there is:

1) New dry wall
2) Styrofoam 2"
3) Old gypsum board somewhat moldy, not sure to what extent
4) some tin foil 1950's?
4) Moor vents (new)
5) roof with airflow to outside vents.

I was thinking of covering it all with poly 6mm, then finish it. Main reason is to keep the mold out and save me from tearing it out and rebuilding.

Good idea, or could it make it worse?



__________________
Jungle is offline  
 
Reply With Quote Quick reply to this message
Old 09-23-2013, 04:55 PM  
kok328
Supporting Member
HRT_SUPPORTER.png
 
Join Date: Nov 2007
Location: Grand Blanc, MI
Posts: 2,137
Liked 92 Times on 81 Posts
Likes Given: 59

Default

I would think it would make it worse if the ceiling can't breath.



__________________
kok328 is offline  
 
Reply With Quote Quick reply to this message
Old 09-24-2013, 08:29 PM  
Drywallinfo
Senior Member
 
Join Date: May 2013
Posts: 140
Liked 27 Times on 22 Posts
Likes Given: 7

Default

This is all dependent on your climate. In cold climates, you do not want water vapor to be trapped in a cold area since it will condense out. Around us in our cold WI climate, a few homes were built that had plastic under the siding - this was such a disaster that these homes had to be torn down. So in a cold climate, the moisture barrier goes just under the interior drywall. This keeps the water vapor out of the cold region, so it stays vapor rather than water.

The styrofoam, if sealed well on the edges, is a vapor barrier and it would prevent moisture from being trapped. If, however, the cracks are not sealed, moisture would get through and then condense on the old sheetrock underneath - this could be the cause of the mold you see. Not good - you may want to clean up or remove that drywall and reinstall or replace the styrofoam. Then put a vapor barrier over the styrofoam and seal up the edges of the styrofoam. I am assuming you live in cold climate.

__________________

- Taping & Finishing Drywall Joints
- Inside & Outside Corner Drywall Joints
- How to Repair Small and Big Holes
- How to Build and Finish Drywall Arches
- How to Apply or Repair Texture
Free Tutorials at http://www.drywallinfo.com


Last edited by Drywallinfo; 09-24-2013 at 08:33 PM.
Drywallinfo is offline  
 
Reply With Quote Quick reply to this message
Old 09-27-2013, 04:56 PM  
handypierson
Junior Member
 
Join Date: Sep 2013
Posts: 7
Default

Mold can be corrected or prevented by using moisture resistant sheet rock, proper ventilation and high gloss paint. Adding foam is only good on the opposite side of the finished side of the sheet rock.

__________________
handypierson is offline  
 
Reply With Quote Quick reply to this message
Old 09-28-2013, 12:05 PM  
Jungle
Senior Member
 
Join Date: May 2013
Posts: 236
Liked 21 Times on 18 Posts
Likes Given: 20

Default

I've never heard of mold being corrected unless it just once getting wet. Looks like the flat ceiling is okay just the slope. There is bunch of old celuose insulation up there along with a birds nest. Not a fun job. What i find is old piece of half rotten reclaimed lumber used in places, but the basic framing seems to be good lumber.



__________________
Jungle is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
is vapour barrier needed when replacing siding? winnipegreno Roofing and Siding 13 08-24-2013 07:01 AM
Foil backed drywall and vapor barrier spartan1979 Insulation and Radiant Barriers 1 03-03-2012 06:34 PM
Basement Insulation Vapour Barrier jgittoes Insulation and Radiant Barriers 1 02-07-2012 09:12 PM
vapor barrier derekm Framing and Foundation 7 09-08-2008 06:06 AM
Vapor Barrier drbert Insulation and Radiant Barriers 2 01-31-2008 06:42 PM