DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   Painting Forum (http://www.houserepairtalk.com/f107/)
-   -   Backbrushing A Metal Door (http://www.houserepairtalk.com/f107/backbrushing-metal-door-14539/)

billhead1 08-08-2012 02:14 AM

Backbrushing A Metal Door
 
I plan to use a 4" foam roller and back brush my steel back door for coating uniformity. The door has a small amount of rust at the bottom, which I was planning to sand with 150 grit paper, prime with red oxide primer, then apply 2 coats of latex paint. I was planning to use a 3.5 or 4-inch synthetic, soft bristled polyester brush to minimize brush marks.


Any suggestions about the surface prep, type of bristle or width of brush?

kok328 08-08-2012 07:55 AM

I've never had any luck creating a powder coat like finish without using spray can paint.


All times are GMT -6. The time now is 02:50 PM.