DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   General Appliance Discussion (http://www.houserepairtalk.com/f11/)
-   -   Dishwasher noise when pumping water out- Frigidaire (http://www.houserepairtalk.com/f11/dishwasher-noise-when-pumping-water-out-frigidaire-6562/)

numbersguy 04-29-2009 05:17 PM

Dishwasher noise when pumping water out- Frigidaire
 
I have a 2005 model Frigidaire dishwasher model FDB1050RES0

It fills OK the goes through its first cycle. When it pumps the water out a loud hum and vibration can be heard coming from the sump pump area. It seems to be dry pumping. If I let it go long enough the pump finally shuts off and goes on to the next cycle. The noise returns the next time water is pumped out again. If you add water to the dishwasher via a pitcher when the hum and vibration starts they will stop but then begin again.

Do I need a drain pump? How do I get to the drain pump on this model?

Oh, in case you are wondering, I have checked the glass fiter and the debris filter screen and found nothing. I removed the filter screen and see nothing in the sump pump tank where the water pools before being pumped out.

Thanks for your help.

nukes00 05-18-2009 08:20 AM

Hey numbersguy, It sounds like you got it in one! Since the sound of the pump gets louder when the water has been pumped out, yes you are dry pumping! That should not be a problem with this type of pump. As it is far better to have a little dry pumping rather than not enough pumping time and have dirty water left to mix with the rinse water for the next cycle, it might be wise to continue to keep the screen and filter clean. If you notice the hum and vibration becoming more pronounced, look into buying a pump now, so that you will have it on hand for the replacement project that will follow.
As far as gettin to the pump, well, you might have to take the unit out from under the counter to be able to do the job easier, rather than working blind under the silly thing. I wouldn't recommend cutting a hole in the basement ceiling just to change the pump! Scope out the cost of your parts, and weigh that against the cost of a new machine. You might be surprised! Good Luck!


All times are GMT -6. The time now is 07:08 AM.