DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (
-   General Appliance Discussion (
-   -   Gas Furnace Problems (

garob 04-18-2013 06:38 PM

Gas Furnace Problems
Lennox furnace start up problem
My G24M3-75A-4 Lennox furnace seems to start okay. Inducer motor starts. After about 30 seconds a valve clicks and the flame starts. Usually after another 30 seconds Circulation fan turns on. But it is not happening and after 90 seconds flame turns off. Inducer motor continues running. After around 70 seconds Circulation fan turns on. From this point after about 50 seconds flame turns on again and runs like normally does.
I'm getting an error message of 4 blinks.

Thanks in advance for the advice.

nealtw 05-14-2013 05:54 PM

Just bumbed this forward for others to see it.
Welcome to the site, hopefully you can get some answers if you haven't solved it by now.

kok328 05-14-2013 06:32 PM

Is there a list of trouble codes on any of the panels that explains what 4 blinks indicate?

ajr4997378 05-14-2013 08:33 PM

Could be either rollout switch or limit switch possibly

All times are GMT -6. The time now is 04:56 PM.