DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   Flooring (http://www.houserepairtalk.com/f13/)
-   -   Bathroom damp-proof wall/ceiling (http://www.houserepairtalk.com/f13/bathroom-damp-proof-wall-ceiling-1545/)

holysmoke 10-30-2006 07:51 AM

Bathroom damp-proof wall/ceiling
 
We have a problem damp-proofing an old bathroom wall above the bath to prevent the moisture penetrating through the plaster wall to the paper insulation of the attic roof.
Above the vertical layer of tiles, this wall/ceiling slopes upwards with the angle of the roof (rising above the end of the bath), and this insulation lies behind it. I have placed special plastic sheeting over the wall and tacked it into place with a tacker. Over that I am placing a very thin, lightweight 6mm plaster board. I have heard that one should not place the board directly on the surface of the plastic sheeting as otherwise the board will not dry out but run with water from the steam. If it is kept off the plastic sheeting, the board will gradually give back it dampness to the room as it dries out. But what is the optimum distance from the sheeting for it to do this? The sheeting is not completely taut and so sags a bit in places. I was thinking of just places little bits of the 7mm board behind the board proper to hold it away from the wall, but would it be better to construct a wooden framework and join the boards on that? Also how should the joints between the boards be filled, and should one do one's best to prevent steam getting through the cracks as far as the plastic sheeting? How? And at the edges of the board wall where the end of the sheet emerges into the open how should one seal it and finish off? (The sheeting turns the corner and we end up with about six inches left on the other vertical house walls which have only brick, not attic insulation behind them.)
Another problem is that the sloping wall joins the ceiling in a kind of curve lasting about 9 inches. I have had to make indent cuts on the far side of the board so it will bend to follow this curve. But the bending operation makes some splits in places. How best seal such splits once the board is in place?
We need to use this very light board to prevent the weight bringing the whole slope down, and have not much room in the bathroom so the smaller the space we lose the better.

glennjanie 10-30-2006 10:46 AM

Hello Anneliese and Welcome to the Forum:
I will share my experience with condensation, insulation and ventilation. In the states we have a green wallboard that is moisture resistant (MR board) which I would recommend in your case. The space behind the board should have either a free flow of air or be filled with insulation (Do not compact the insulation). In areas too small to get fiberglass batt insulation into you could consider foam insulation board (Styrofoam). The room should have a vent-fan ducted to the outdoors to rid the room of steam. Try to target complete air change in the bathroom every 3 minutes and connect the fan to the light circut. If the light is on the fan should run.
Your vapor barrier can be tightened by heating it with a hair dryer (works on polyethelene). Then, with the proper insulation and/or ventilation, you may put the MR board directly on the vapor barrier. I recommend the fiberglass cloth tape and regular drywall compound for the joints and cracks. Enjoy your project and let us know how it turns out; we like pictures too.
Glenn


All times are GMT -6. The time now is 08:14 PM.