DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   Flooring (http://www.houserepairtalk.com/f13/)
-   -   Removing Viynl Help (http://www.houserepairtalk.com/f13/removing-viynl-help-1359/)

TxBuilder 09-19-2006 05:29 PM

Removing Viynl Help
 
I am remodeling a bathroom and right now am trying to strip the floors.

There is 1 layer of viynl that is fairly new and came right off.

Then there is another layer that probably was installed when the house was built 50+ years ago.

That layer is coming off ok but it's leaving a layer of paper/glue behind.

I tried scraping but it's stuck very, very well.

Any suggestions on solvents or techniques to get this stuff off?

tooltime 09-20-2006 01:21 AM

A hair dryer (or other non-flamable heat source) might soften it up enough.
I am sure there are other options floating around.. but none are coming to me at the moment.

Square Eye 09-20-2006 08:36 AM

Using solvents to remove flooring is never a really good idea, most have a low flashpoint, which puts you at risk of fire or explosion. Then residue left over from the solvents can cause problems with adhesives and the new floor covering.

The best thing I have found for removal has been a long handle heavy duty scraper with replaceable blades. The scrapers are heavy metal and will dig right under the floor covering. The commercial stripping machines are good, but will leave you needing to finish some areas by hand anyway.

carpettool.net/scrapers_strippers

This one, the model 375 has an 8" blade and a 59" handle.
http://www.carpettool.net/375_more_small.jpg

No easy solution, sweat and a heavy scraper is the best. A hot air gun may help, but some adhesives will not respond to heat at all. The old flooring will just delaminate and you will have backing still stuck to the floor.

Whatever you do, you may need a coat of floor leveler when you're done. Just a skim coat. It will dry quickly, so don't mix much at a time. After it sets, you can sand it a bit and get a smooth finish.


All times are GMT -6. The time now is 06:28 AM.