DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Decks & Patios > New member needs help




Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 03-28-2014, 01:43 PM  
nealtw
Contractor
 
Join Date: Nov 2010
Location: vancouver, b.c.
Posts: 9,462
Liked 748 Times on 668 Posts
Likes Given: 1306

Default

We see this in new construction from time to time but does have requirements. It must be treated as a roof. It would have a slope of 1/4" per ft and like a roof the flashing should go up the wall I think 6". That creates a few problems like there should be a 6" step down from the door and the bottom of the siding has to be removed and replace after. The deck is usually covered with vinyl deck membrane which is wrapped up the wall and up the post.
The cheat for this house would be to lower the floor to be aprox. level with or just above the top of the foundation or the required 6" and the deck plywood carry out 1 or 2" past the foundation so the membrane can be done without removing the siding. Then a flash would be slipped up under the siding and a decritive board would be added below that and the post would be dressed out.
Best if the level of the floor is 1 1/2" above the foundation as just like any other roof there has to be venting above the insulation and below the sheeting.
We have done this to a few old houses and it does pass inspection.



__________________
nealtw is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
New member house92 Introductions 1 10-07-2009 07:49 AM
Yet another new member forten Introductions 2 01-15-2008 12:26 AM
New member DavidUL Introductions 6 12-24-2007 03:28 PM
Hello from a New Member eugenekaraliou Introductions 0 11-05-2007 11:07 AM