DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   Bricks, Masonry and Concrete (http://www.houserepairtalk.com/f17/)
-   -   concrete adhesive (http://www.houserepairtalk.com/f17/concrete-adhesive-5700/)

fletton 12-09-2008 02:36 PM
concrete adhesive
 
Hi Everyone

Have a concrete birdbath about eighteen inches wide which has got broken in two. Is it possible to get a glue which would stick it together. It is only about 3/4 of an inch thick.


Thanks

Fletton

nukes00 05-18-2009 09:12 AM
Ya might try PL375.

Nestor_Kelebay 05-20-2009 01:37 PM
There is also LePage's "PL Premium" which is a moisture cure polyurethane construction adhesive. It's about the strongest construction adhesive I know of. I takes 24 hours to cure to a bond that's about 3 times as strong as other construction adhesives. Also, until it cures, you can clean it up with mineral spirits. So, you can glue your bird bath back together with PL Premium, wipe away any excess adhesive with paper towels dampened with mineral spirits, and then just leave it alone while the adhesive cures (for a near invisible repair).

yesitsconcrete 05-23-2009 02:11 AM
3/4" ? ? ? very unlikely - there's just not enough mass to ' glue ',,, IF you set the piece in place well supported promise not to EVER move it, you could,,, i suspect the temptation'll be too large to resist & it'll break again, tho :D

Nestor_Kelebay 05-23-2009 12:51 PM
Quote:
Originally Posted by yesitsconcrete (Post 30786)
3/4" ? ? ? very unlikely - there's just not enough mass to ' glue ',,, IF you set the piece in place well supported promise not to EVER move it, you could,,, i suspect the temptation'll be too large to resist & it'll break again, tho
Huh?

OK, I give up.

Why wouldn't PL Premium glue two pieces of concrete together with the same bond strength as it glues two pieces of wood together?

If the bond strength were the same, why would you say he/she couldn't move the birdbath without likely breaking it again?

I use PL Premium to glue 1/8 inch thick steel "roofs" to my parking fence fence posts, and there's no way that steel will come off that wood without using a hammer and/or pry bar. Why would it fall apart if it's glueing concrete to concrete?


All times are GMT -6. The time now is 09:30 PM.