DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   Framing and Foundation (http://www.houserepairtalk.com/f32/)
-   -   Garage Wall Bracing (http://www.houserepairtalk.com/f32/garage-wall-bracing-3789/)

chuckles 03-16-2008 04:46 PM

Garage Wall Bracing
 
1 Attachment(s)
I noticed the the bracing on one end of the garage came loose - the vertical 2x4 split and the wall is bowing out about 2".

1) Any suggestions on how to fix this?
2) Should I try to push the wall back?

Thanks!

triple D 03-17-2008 12:54 AM

Ouch!
 
I would definitely try to push the wall in. If you can't push, pull them together with a cumalong or fowler until the wall is straight. You should leave old 2x4 in place, this is fastened to plywood. Pull diagonal brace off, then screw 2x4 back together through crack with 3" screws, then add another sistered to it with screws, 3" again, this will repair 2x4. Now the main problem...this board is not for holding the wall, it is for roof support. What you need to do is buy some 2x6's, enough to go across garage end to end. If you have to use two then overlap them at least 4'. Fasten this on top of now straight wall on opposite side of diagonal brace. Screw through this with a few 4" screws, into your 2x4's and also diagonally down into top of wall. Then fasten to house side in same manner, or screw a cleat to wall. If you need help on this side just ask, we're here. Good luck......

hondadrv24 03-18-2008 07:04 PM

Like triple D said you need to have a stringer across the rafters of the garage to hold them in place. I think 2x4 would work but not sure. take the diagonal brace out, then put the stringer up before you attempt to pull this end wall in to where it needs to be, that way you will have a solid place to pull against the end wall. after you get the wall pulled back in and fastened fix the 2x4 like Triple D said.
good luck


All times are GMT -6. The time now is 09:37 AM.