nash123

Good morning all,

I have a floating plug and also a stand pipe for our 4" (clay pipe, I think) floor drain in our basement. However, with the recent rains, I noticed that neither closes the drain completely, sewer water came up in the basement. While the floor drain size and plug sizes are 4", there remain small gaps around the rubber even when I tighten the screws completely. The gaps are away from the screw locations. It's as if the 4" pipe isn't perfectly circular. I tightened everything and I poured water through the gaps, and the water went down the pipe, meaning it is not completely sealed.

The plug for the stand pipe that I tried to use is this:

"Campbell Basement Flood Stopper"

https://www.google.com/search?q=Campbell%22+Basement+Flood+Stopper&aq=f&o q=Campbell%22+Basement+Flood+Stopper&aqs=chrome.0. 57j0j60l3j62.309j0&sourceid=chrome&ie=UTF-8#tbm=shop&sclient=psy-ab&q=Campbell+Basement+Flood+Stopper&oq=Campbell+B asement+Flood+Stopper&gs_l=serp.3...3996.3996.1.42 67.1.1.0.0.0.0.84.84.1.1.0...0.0...1c.1.9.psy-ab.5zzz4DONQv4&pbx=1&bav=on.2,or.r_qf.&bvm=bv.4551 2109,d.aWM&fp=42e7d46ac324ce54&biw=1680&bih=935

and my plug looks like this (not the same product, but similar):

http://www.amazon.com/Gen-Wire-Spring-4FH-Flood-Guard/dp/B001B00LD4/ref=pd_sxp_grid_i_0_1

any advice? Should I try to ad another layer of rubber around this (although it is going to be very tough since the gaps are small?)

Thanks

Brent

nealtw

I am just bumping this so others see it!

elbo

by now you may have already solved your problem, but if no, try this remove the plug, clean the mating surfaces on the pipe and the plug, reduce the diameter of the plug by unscrewing the the screws, using a polyurethane caulk coat the rubber seal thickly then reinstall the plug and re-expand the plug to its tightest fit, then hope that it doesn't rain until the caulk sets
Good luck