![]() |
How to determine the lowest point in basement?
Whats the best way to determine where the lowest point in your basement is? Can someone give me some tips? Im looking to install a sump pump.
Thanks, SumpChump |
sumpchump, welcome to House Repair Talk, if you don't have carpet on the floor just drop a marble or ball and watch where it rolls. It will usually find the lowest point.
|
Quote:
Thanks, SC |
well
You want to find where the water goes...get some water on the floor.
Use a five gallon bucket of water poured onto areas of the floor to find the low spot...then a shopvac to clean it up soon as possible. |
Quote:
You may want weep holes in the walls at the bottom to equalize the water level. 5 gals will give you a depth of 1/16" in an 11'x11' room. And a marble will work if you first put down a large sheet of tempered Masonite or glass or Plexiglass. You are kinda' looking for an average slope. One site recommended a slope of 1 in 100, like a rain gutter, but that seems steep. " SUMP PUMP INSTALLATION: Installation of a pump and its location will depend on the type of water problems you have and what the local plumbing and electrical codes require. If you install a pump only as a safeguard against an unexpected flooding situation, and have only a slight amount of water tinder normal conditions, locate the sump pump in the lowest part of the basement near an outside wall. Locating the sump in a low spot will assure that water will run to the sump. . . . If the water problem is really serious, you may need to cut out small channels in the floor to funnel the water into the sump. These channels should be more like depressions rather than trenches. Make them approximately 2" wide by about 1 " deep. Draw the position of the channels on the floor at the same time you lay out the floor for the sump system. " |
Quote:
|
Quote:
|
I think the marble idea is probably as accurate as you need. If there are partition walls in the basement, and the marble comes to rest against a partition wall, simply move it to the other side of the wall and let it go again.
If you do that from several points in your basement, and it ends up at the same place each time, that's your lowest point. However, I expect Wuzzat? is probably right. There are probably several dips in your floor, and puddles will form in all of them in the event of a flooded basement. Still, a shallow puddle can be removed with mop and pail. |
My basement is currently under 3" of water as we just received 7-8" of rain in 3 days.
Time for a sump pump! I dont see how a marble will tell me the lowest point in my basement since our basement is approx 1000 sq. feet. Im sure the concrete floor is not perfect and will have some dips so the marble may roll in many different directions depending on what side of the floor I place it on. Same issue with the bucket of water idea. All these sites tell you to install the pump at the lowest point in your basement, but none tell you how to find it! And before anyone asks we are getting water up through the cracks in the floor. Seems to happen every 4-5 years when we get 6-8" of rain in 2-3 days. My backyard is approx 6' below my neighbors house and all that ground water saturates my yard and then my basement. Joy...joy... Has anyone ever used a 12 or 16ft 2x4 with a level on it? Would this work (assuming I can find a 12-16 ft 2x4 that is straight) SC |
Quote:
Instead of a 2X, with the aid of a helper, stretch a string and a level that hangs on the string, you can get them at most hardware stores. You wont have to try and find a straight 2X. ...I really didn't mean fill the house with water;) |
| All times are GMT -6. The time now is 01:21 PM. |