DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   Plumbing Forum (http://www.houserepairtalk.com/f33/)
-   -   Shower install on outside double wall construction (http://www.houserepairtalk.com/f33/shower-install-outside-double-wall-construction-12979/)

boerssd 01-16-2012 11:55 AM

Shower install on outside double wall construction
 
G'day,
I'm about to tear out and replace a badly installed and badly leaking shower. My intent is to do it right - do it once. I have two specific question areas I want to address. The first has to do with the outside wall which is double wall construction - the second question has to do with mating the tiled walls to an acrylic shower pan.

Right - on to the first question... My home has been constructed using double wall construction. The outside wall is 2x10, and the inside wall is 2x4. The sheathing and moisture barrier (6mil plastic) is sandwiched between these two walls. Both walls are insulated. So - in order from outside to inside, we have a) wood siding, b) insulation & 2x10 studs, c) 1/2" OSB, d) 6 mil plastic, e) insulation and 2x4 studs, f) drywall. The shower is installed against this double wall. What would be the proper order of materials from that inside wall? I think an additional vapour barrier would be a bad idea as there is already one sandwiched between the double wall. Do I put cement board only onto the studs and tile on top of that?

My second question is about mating the tile to the acrylic shower pan. I intend to use cement board on the walls, and then tile on top of that (unless I'm told differently). Should the cement board run down to the top of the flange on the shower pan, keeping the surface flush with the inside of the pan, or should the cement board drop down inside the pan, over the top of the flange? Either way, the tile comes down inside the pan and would be caulked along the bottom where it meets the acrylic. Correct?

Any advice would be appreciated. Thanks!!

Sean.

nealtw 01-16-2012 03:31 PM

Once you have this pulled apart you will be able to tell how this is working to date. I would be inclined to bring the bearier to the inside next to the board around the tub. I wouldn't just remove it, I would cut it nice and tape new to it re-insulate and then vapour bearier. And don't forget to seal it to the floor.
Stop the board at the flange and tile over the flange.

boerssd 01-19-2012 06:10 AM

I found the installation manual for the shower base I have on order online. It clearly shows running the wallboard down inside the shower pan to within 5/8" of the bottom of the pan. I guess I should follow the manufacturers direction...

http://www.us.kohler.com/onlinecatalog/pdf/1064933_2.pdf

Sean.

nealtw 01-19-2012 07:04 PM

Yes it dose and note the furring strips for the rest of the wall.


All times are GMT -6. The time now is 11:22 PM.