DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   Plumbing Forum (http://www.houserepairtalk.com/f33/)
-   -   Whirlrpool type tub, mold in system (http://www.houserepairtalk.com/f33/whirlrpool-type-tub-mold-system-16547/)

TedW 09-22-2013 12:38 PM

Whirlrpool type tub, mold in system
 
Hi all, I hope plumbing is the right forum to post this.

A whirlpool tub in one of the rental units I manage is leaking what appears to be black mold from a couple of the jet outlets. The tenant in that unit runs bleach water through the system to clean it out, but it always comes back. She does not use the whirlpool system otherwise, just the shower.

I asked if she runs clean (non-bleached) water to rinse the system after using bleach, and she does. So I suggested that next time she does not do the "rinse cycle" and just leave the bleached water in the system, thus preventing it from creating mold again.

Am I on the right track with this advice, or is there potential of damaging the system? My concern is the bleach eating away at any internal seals or other possible damage by leaving the bleached water in there.

Any other suggestions on the proper way to prevent mold build-up in the system?

Thanks

nealtw 09-22-2013 02:02 PM

Welcome to the site, this might be usefull.
http://www.wikihow.com/Clean-a-Jetted-Bathtub

TedW 09-22-2013 03:48 PM

Thanks Neal, that's just what I needed. The bad news is the article mentions some manufacturers recommend against using bleach, as it may eventually dry out any internal rubber seals. So my advice to the tenant to leave the bleach water in the system is some really bad advice. Well.. that's why I asked.

I'll direct the tenant to that article and clarify that I was wrong about leaving the bleach in the system. Thanks again :)


All times are GMT -6. The time now is 10:36 PM.