DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Roofing and Siding > Is Drip edge needed in this situation?




Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 05-04-2009, 09:31 AM  
Dimeron
Junior Member
 
Join Date: May 2009
Posts: 12
Default Is Drip edge needed in this situation?

Hello, recently I have just installed the new architectural shingles (40 years), and the contractor did not include drip edge.

His reasoning was that since the shingle overhang is between 3/4th of an inch to 1.5 inches, and since my roof slope is fairly steep, a drip edge is not really needed except for aesthetic reasons.

Just wondering if I still should get some drip edges or not. The shingles has not completely self sealed and become brittle yet, so now would be the best time to install those.

Thank you for your time.



__________________
Dimeron is offline  
 
Reply With Quote Quick reply to this message
Old 05-04-2009, 10:35 AM  
glennjanie
Senior Member
 
Join Date: Mar 2006
Posts: 2,990
Liked 2 Times on 2 Posts

Send a message via AIM to glennjanie
Default

Welcome Dimeron:
Adding the drip edge now would cause more damage than the benefit. I would let it go.
Glenn



__________________
glennjanie is offline  
 
Reply With Quote Quick reply to this message
Old 05-04-2009, 11:25 AM  
DaveyDIY
Extreme DIY Homeowner
 
DaveyDIY's Avatar
 
Join Date: Apr 2009
Posts: 82
Default

How steep is your roof?
While that may be cause not to have them on the eave, I can't see leaving them off the rakes (gable ends)
Did he use tar paper?
Ice & water shield?
Did he tell you in advance he would not use it?
Or did he tell you afterwards?
Or did you find out afterwards & then he put forth his reason for not using them?
Is he going to warranty any problems due to his ommission? and for how long?

I'm sure houses have existed for a long period without drip edges
But the drip edge has 3 or more ridges that help prevent water from flowing in from the side. In wind driven rain this could be very important

__________________
DaveyDIY is offline  
 
Reply With Quote Quick reply to this message
Old 05-05-2009, 08:52 AM  
Daryl in Nanoose
Senior Member
 
Daryl in Nanoose's Avatar
 
Join Date: Feb 2006
Location: Nanoose Bay, BC
Posts: 762
Liked 3 Times on 3 Posts
Likes Given: 5

Default

I agree with glenn.

__________________

[url]http://edhome.shawwebspace.ca/[/url]

Daryl in Nanoose is offline  
 
Reply With Quote Quick reply to this message
Old 05-05-2009, 02:49 PM  
Dimeron
Junior Member
 
Join Date: May 2009
Posts: 12
Default

DaveyDIY

it is between 35 and 45 degree I think. Ice/water shield and tar paper were used, and he did not include the drip edge in the original estimate either.

glennjanie and Daryl in Nanoose, thanks, I think I will go without drip edges for now.

Thanks again for the advice everyone. Cheers.



__________________
Dimeron is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Drip Edge/Flashing Rchaffin Roofing and Siding 6 04-22-2009 07:14 PM
Roof valley drip back guyod Roofing and Siding 5 08-31-2008 11:01 PM
Poor Trim Situation mjc1234 Decorating and Design 2 07-09-2008 06:11 PM
So what is the average cost of geothermal HVAC in retrofit situation? apsinkus HVAC 6 06-19-2008 11:50 AM
Flashing/drip edge on roof - questions & advice Westy Roofing and Siding 4 09-24-2007 07:37 PM