DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Roofing and Siding > roof vents to cut cooling costs




Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 09-26-2005, 09:55 AM  
sharon
Junior Member
 
Join Date: Sep 2005
Posts: 5
Default roof vents to cut cooling costs

Are the vents you can install in your roof really worth it? I mean do they really make a difference in your cooling costs? If so, which ones are the best?

sharon



__________________
sharon is offline  
 
Reply With Quote Quick reply to this message
Old 10-11-2005, 05:14 PM  
Bill
Member
 
Join Date: Sep 2005
Posts: 30
Default

YES THEY ARE NECESSARY!!! When it gets hot outside the air comes in from your soffit and rises under your roof sheathing. This warm air goes out the vents thus your attic space is cooled. This helps in the winter also by removing water vapor from your attic area. The condensation will cause your insulation to be compromized. In very cold area like Minnesota etal where Ice dams are common the venting along with insulation minimize the ice dam.



__________________
Bill is offline  
 
Reply With Quote Quick reply to this message
Old 10-11-2005, 09:51 PM  
FirTrader
Member
 
Join Date: Sep 2005
Posts: 51
Default

It also lets your shingles live about 10 years longer. Shingles fail much faster if there's no air-space below the sheeting on the roof to provide some cooling.

__________________
FirTrader is offline  
 
Reply With Quote Quick reply to this message
Old 03-01-2006, 01:40 PM  
glennjanie
Senior Member
 
Join Date: Mar 2006
Posts: 2,992
Liked 2 Times on 2 Posts

Send a message via AIM to glennjanie
Default

I reccommend the use of a continous ridge vent and continous eave vents; its called the "ice house effect" which allows air to move up the decking from bottom to top of the whole roof. A rule of thumb is to calculate the sqrare feet of attic space and use one square inch of ventilation for each square foot of space. Cardinal law!!!! Do not cover vents in the winter time; it causes sweating in the attic--then rotting--and poor insulation. If your home is properly insulated and the roof properly vented yours will be the last in the neighborhood to melt the snow off.

__________________
glennjanie is offline  
 
Reply With Quote Quick reply to this message
Old 03-02-2006, 10:55 AM  
mickmar
Junior Member
 
Join Date: Nov 2005
Posts: 21
Default

sharon, the more vents you have the better. You want the temperature in your attic the same as the outdoor temperature. The only ones that I would not install are the whirlybird ones you see. They can develop a squeeck and drive you nuts. Talk to a good insulation company, venting is just as important as insulation. Mick

__________________
mickmar is offline  
 
Reply With Quote Quick reply to this message
Old 08-28-2006, 10:17 AM  
MONTY
Junior Member
 
Join Date: Aug 2006
Posts: 8
Default A Remedy To Hot Attics

TEXAS A & M DID A STUDY & FOUND THE WHIRLYBIRD VENTS RELEASE ZERO HEAT WHILE MOVING. THERE IS NO WAY FOR THIS DESIGN TO "DRAW" HEAT OUT WHEN TURNING.
ANOTHER OPTION OR TWO IS RADIANT BARRIER PLACED OVER CEILING JOISTS. SEE

What Is Radiant Barrier Reflective Insulation?
Radiant barrier insulation is a reflective insulation system that offers a permanent way to reduce energy costs. Radiant barrier insulation systems reflect radiant heat energy instead of trying to absorb it. A pure aluminum radiant barrier reflective insulation is unaffected by humidity and will continue to perform at a consistent level no matter how humid it may be. A radiant barrier insulation system is a layer of foil facing an airspace and is installed in the envelope of a building.

Most people are familiar with traditional insulating materials such as fiberglass, cellulose, Styrofoam, and rock wool. These products use their ability to absorb or resist (slow down) convective and conductive heat transfer to insulate (R-value). A third, seldom discussed but dominant form of heat transfer exists: radiant heat transfer. What are the differences among the three forms of heat transfer?





Conductive: Direct contact. If you touch a pot on the stove, this is conductive heat transfer.

Convective: Steam, moisture. If you put your hand above a boiling pot, you will feel heat in the form of steam. This is convective heat transfer.

Radiant: Electromagnetic. Step outside on a sunny day and feel the sun’s rays on your face. You are feeling radiant heat transfer. All objects above absolute zero (-459.7 degrees F.) emit infrared rays in a straight line in all directions.

A radiant barrier reflects radiant heat energy instead of trying to absorb it. What does this mean in your home or business? During the winter, 50-75% of heat loss through the ceiling/roofing system and 65-80% of heat loss through walls is radiant. In the summer, up to 93% of heat gain is radiant. If you are depending on R-value (resistance) alone to insulate against heat gain and loss, remember that thin layers of fiberglass are virtually transparent to radiant energy and are affected by changes in humidity (moisture levels). A 1-1/2% change in the moisture content of fiberglass insulation will result in a 36% decrease in performance (referenced from HVAC Manual 10.6; McGraw-Hill). A pure aluminum radiant barrier is unaffected by humidity and will continue to perform at a consistent level no matter how humid it may be.


--------------------------------------------------------------------------------
Testing and Approvals
Building Officials and Code Administrators
International Conference of Building Officials
Southern Building Code Congress International
Metropolitan Dade County (FL) Building Code Compliance Dept.
United States Testing Company
Tennessee Valley Authority
Tennessee Technological University
State of California
Oak Ridge National Laboratory
Texas A & M University
ALSO SEE:

NASA Quest > Aerospace Team Online 80% ||||||||||||||||||||
... thermal protection materials. An example of a thermal protection material
is the ceramic tile on the Shuttle Orbiter. It uses heat ... 2002-11-01
+ Highlighted
http://quest.arc.nasa.gov/people/journals/aero/raiche/arcjets.html - 16k

/////////////////////////////////////////////////////////////////////////////////////////////////////////////////////
RADIANT BARRIER
Technology Transfer Program - At Home with NASA 60% ||||||||||||||||||||
... Their NASA-derived Smart-House Radiant Barrier is designed to reflect away 95 percent
of the sun's radiant energy. Pretty cool! Back to "At Home With NASA". 2005-10-12
+ Highlighted
http://techtran.msfc.nasa.gov/at_home/home5.htm - 4k


AT Technology Transfer Homepage 50% ||||||||||||||||||||
... As her alarm sounds, Amanda awakes refreshed and ready to face her busy day after
sleeping snugly in a home insulated with radiant barrier technology developed ... + Highlighted
http://technology.jsc.nasa.gov/space_foundation.cfm - 28k


Innovation (Jan/Feb 97) - Insulation 40% ||||||||||||||||||||
... Energy Q Radiant Barrier is the commercial name for the material, manufactured
and marketed by Tech 2000 LLC of Roswell, Georgia. ... 1997-02-01
+ Highlighted
http://nctn.hq.nasa.gov/innovation/Innovation51/insulatn.htm - 4k

/////////////////////////////////////////
OPTION # 2 IS A CERAMIC COATING OVER SHINGLES IN ANY COLOR MATCH.
THIS
SEE:
http://www.mascoat.com/
INFRARED SURVEY;
sale-192056753@craigslist.org

THERE'S YOU SOME OPTIONS,
MONTY / FlatRoofExpert@aol.com



__________________
MONTY is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Raising Roof Pitch JulieC Roofing and Siding 14 03-04-2012 05:22 PM
Patio roof to house attachment question mobilemike Roofing and Siding 2 09-23-2008 07:31 AM
A/C Question: Just replaced Fan Control Unit and now the Blower false starts cooling redmachodevil HVAC 0 08-10-2008 10:14 AM
Attic vents in the dry Southwest RickABQ Roofing and Siding 10 01-19-2008 03:40 PM
attic needs vents! ALPS Flooring 6 07-17-2006 01:06 PM