DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   General Home Improvement Discussion (http://www.houserepairtalk.com/f45/)
-   -   Dead bolt question (http://www.houserepairtalk.com/f45/dead-bolt-question-16256/)

cut_un 07-12-2013 12:58 PM

Dead bolt question
 
Used the front door yesterday(hardly ever use the thing,,,,) I noticed the Kwikset dead bolt was loose. I removed to set screw holding the thumb latch and slipped the latch itself off. BUT... can not seem to slide the inside cover plate off, When I look at it up close, looks to be a small flange holding it on ,one that will not allow it's removel.... I figure if I remove the inside cover, I should be able to get to the screws to tighten up the whole bolt assembly.... I hate to pry onthe cover too hard and have to buy a new dead bolt....which is usually the case,with my luck:o Thanks guy!

nealtw 07-12-2013 05:56 PM

http://www.kwikset.com/Customer-Support/How-To-Center/Installation.aspx


All times are GMT -6. The time now is 04:32 PM.