DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > General Home Improvement Discussion > Installing exterior wall insulation w/ reflectix.




Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 09-02-2010, 01:21 PM  
Mojojojo
Junior Member
 
Join Date: Sep 2010
Location: Nona
Posts: 2
Default Installing exterior wall insulation w/ reflectix.

I've got a cape cod in northern virginia and I'm redoing the insulation on the exterior walls. The existing insulation is kraft w/ about an inch to the drywall and offset from the siding about a half inch. I was hoping to replace the insulation w/ non faced insul and then put in the reflectix as stated in the reflectix instructions. http://www.reflectixinc.com/basepage...&pageIndex=561

My boss who does a lot on his house said the primary thing to do is stop airflow so he suggested using aluminum tape along the edges of the reflectix and wrap the tape around the studs to create an air seal. In doing this I'll have about 3/4" air gap between the drywall (I was planning on green board just for overkill) and the reflectix barrier. He said that the air inside here should be roughly the same temp as the inside provided the tape seals correctly and I shouldn't have to worry about condensation inside this gap. Also he said wrapping the aluminum tape around the studs is fine since the outer edges of the studs can breathe.

My questions are
A. Since the siding is offset from the stud walls should I not risk putting in the non-faced insulation and stick w/ kraft? There are some thin strips I can use to hold it in place but the kraft siding held it in place before. Since I can't place it directly on the boards holding the siding I don't want it to fall down and also want to make sure any air needed to breathe remains intact (I have no attic vents or soffits along the gutters, just at the roof peak so I assume this was used instead of vents). Reflectix specifically says not to use kraft insul for this type of application. I can try to put the styrafoam offsets inside to keep both airflow and hold the insul off of the siding board. Should I scrap the reflectix idea entirely because of this?
B. Was it a good idea in the first place?
C. if I nailed super tiny, virtually unnoticeable holes at the top and bottom of the drywall to keep the temps inside this gap consistent, is that overkill?
D. Is the airflow too low once I install the reflectix to even concern myself with taping up the sides to completely seal it off?



__________________
Mojojojo is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
Exterior wall insulation using reflectix and creating air barrier Mojojojo General Home Improvement Discussion 0 09-02-2010 12:53 PM
Installing new window into existing wall, exterior question... Dr_Jim Windows and Doors 11 08-11-2009 07:50 PM
Can I use opposite side of exterior brick wall as interior wall finish murray382 Bricks, Masonry and Concrete 1 06-24-2009 04:06 PM
Need Help Exterior Wall Bolcheck Bricks, Masonry and Concrete 4 10-03-2007 03:45 PM
stylish exterior siding & insulation for exposed cinderblock foundation LoneJeeper General Home Improvement Discussion 5 10-20-2006 05:20 PM