DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   General Home Improvement Discussion (http://www.houserepairtalk.com/f45/)
-   -   the toilet that runs! (http://www.houserepairtalk.com/f45/toilet-runs-4133/)

JeffC 05-04-2008 12:23 PM

the toilet that runs!
 
We just moved into our home and we have a bath in the basement. It has a titan toilet installed. For the last week or so, the tank seems to intermittently fill or something. You hear it make a water rush noise for about 3 seconds and then its done. It repeats this about once every 5 minutes. I have been through the tank and comparing it to a working system that I have upstairs but I can not detect what the problem is. I am wondering if any of you may have run across the same issue and might want to offer some insight;)

Thanks.

glennjanie 05-04-2008 02:48 PM

Hello Jeff:
This is a common problem with water closets (commodes). It is caused by two common problems; you will find you have one or the other but the repair is fairly easy.

Either your 'flapper' is leaking by and allowing the tank valve to open and re-fill it, or your fill valve is set to make the water run into the overflow tube which would also make the valve kick in again to fill to the level that shuts off the valve.

You can pick up a new flapper at Wal-Mart, Lowe's, Home Depot or your local hardware store. Turn the valve down on the wall off to stop the flow to the commode, remove the flapper and take it with you to get the new one. There are a few different kinds and you need the one that works. Simply disconnect the chain that pulls the flapper open, remove the overflow hose at the top and slide the flapper up the overflow tube or slip it off the two spurs at the side. Re-insert the new flapper in reverse to the way you took it out and turn the water back on.

If it is the overflow tube that is draining the water out, you will need to adjust the valve to kick off at a lower level. For a ball cock valve, you may bend the arm to make the ball come higher or tighten a screw in the center of the tower to make it shut off at a lower level. For a tower float, there is a wire on the side of the tower and a butterfly depth adjustment on the float. Simply squeeze the butterfly togather and slide it up or down to get the level you need.

Let us know if you need further help.
Glenn

JeffC 05-04-2008 10:26 PM

Thank you for the response Glenn. Sounds easy enough to do. Will tackle that in the morning. Will let you know how I make out.


All times are GMT -6. The time now is 10:38 AM.