DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > General Home Improvement Discussion > the toilet that runs!




Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 05-04-2008, 12:23 PM  
JeffC
 
Join Date: May 2008
Location: Detroit - Close, Michigan
Posts: 3
Send a message via MSN to JeffC Send a message via Yahoo to JeffC
Default the toilet that runs!

We just moved into our home and we have a bath in the basement. It has a titan toilet installed. For the last week or so, the tank seems to intermittently fill or something. You hear it make a water rush noise for about 3 seconds and then its done. It repeats this about once every 5 minutes. I have been through the tank and comparing it to a working system that I have upstairs but I can not detect what the problem is. I am wondering if any of you may have run across the same issue and might want to offer some insight

Thanks.



__________________
JeffC is offline  
 
Reply With Quote Quick reply to this message
Old 05-04-2008, 02:48 PM  
glennjanie
Senior Member
 
Join Date: Mar 2006
Posts: 2,990
Liked 2 Times on 2 Posts

Send a message via AIM to glennjanie
Default

Hello Jeff:
This is a common problem with water closets (commodes). It is caused by two common problems; you will find you have one or the other but the repair is fairly easy.

Either your 'flapper' is leaking by and allowing the tank valve to open and re-fill it, or your fill valve is set to make the water run into the overflow tube which would also make the valve kick in again to fill to the level that shuts off the valve.

You can pick up a new flapper at Wal-Mart, Lowe's, Home Depot or your local hardware store. Turn the valve down on the wall off to stop the flow to the commode, remove the flapper and take it with you to get the new one. There are a few different kinds and you need the one that works. Simply disconnect the chain that pulls the flapper open, remove the overflow hose at the top and slide the flapper up the overflow tube or slip it off the two spurs at the side. Re-insert the new flapper in reverse to the way you took it out and turn the water back on.

If it is the overflow tube that is draining the water out, you will need to adjust the valve to kick off at a lower level. For a ball cock valve, you may bend the arm to make the ball come higher or tighten a screw in the center of the tower to make it shut off at a lower level. For a tower float, there is a wire on the side of the tower and a butterfly depth adjustment on the float. Simply squeeze the butterfly togather and slide it up or down to get the level you need.

Let us know if you need further help.
Glenn

__________________
glennjanie is offline  
 
Reply With Quote Quick reply to this message
Old 05-04-2008, 10:26 PM  
JeffC
 
Join Date: May 2008
Location: Detroit - Close, Michigan
Posts: 3
Send a message via MSN to JeffC Send a message via Yahoo to JeffC
Default

Thank you for the response Glenn. Sounds easy enough to do. Will tackle that in the morning. Will let you know how I make out.

__________________

Last edited by JeffC; 05-05-2008 at 05:42 AM.
JeffC is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
New Lo-Flo Toilet Kerrylib Plumbing Forum 8 04-13-2009 07:04 PM
Leaking toilet kypeake Plumbing Forum 5 06-20-2008 08:50 AM
Tub drains slowly. Toilet water into tub? FearfulOfAsbestos Plumbing Forum 6 06-04-2008 12:45 AM
Choosing a toilet for an apartment davefoc Plumbing Forum 2 06-03-2008 12:08 PM
Pipes knock ALL DAY after toilet runs!!!! Quiet77 Plumbing Forum 2 07-17-2007 08:55 PM