RodgerBouter

Picture Attachment Post ....

RodgerBouter

Sorry for the horrible picture but it's just to give you a basic visual rep.

I am remodeling my bathroom and I am going to put the toliet were the shower stall is and shower stall where the toliet is.

I have to frame the new shower stall in now.

I want to build two half walls 6" wide that jet out like so to form the shower stall. The walls will only be about 3.5-4' tall and the rest will be glass.

Any insight into how I should go about building these two walls to make sure they are plenty strong would be appreciated it.

Besides boxing the frames, building a bottom connecting frame, sheetrocking them, anything else? Should I fill the walls with any material to make it more solid?

glennjanie

Hello Rodger and Welcome to the Forum:
Some long threaded rods will anchor the walls permanently. Use 2 in each wall, place them near a stud and countersink the top to leave a smooth surface for the sheetrock; connect the other end to a 2" X 6" block under the floor joists. The normal nailing should also be done but the 4 rods will make the permanent anchor for the 2 walls. Be sure to use moisture resistant wall board or, even better, use the cementious wall board. I wish you the best on your project and we would appreciate pictures of your progress.
Glenn

Square Eye

The absolute best way to anchor a knee wall is to cut the floor for a post to pass through. The post should be flush with the bottom of the joists.Then a 2x under the joists and another 2x in between the joists and fastened solid to the joists and the post. Tight fit is the key here to reduce movement.

The 2x under the joists should attach to at least 3 floor joists. In the case of an upstairs knee wall, there should be bridging between the next joist spaces on each side of the space where the post passes through the floor. This means ceiling work will be necessary. Once again, tight fit is the key to less wiggle.

The post can be 2 2x4s or a pair of 2x6s nailed together with 1/2" plywood ripped and fitted between them. Trace the end of the post right on the floor and cut to the inside of the lines.

Another 2x fastened against the bottom of the floor and attached to the post at the top will make up some for a loose cut. Tight fit is best.


Welcome to the forum Rodger,
Tom

__________________
[URL="http://www.houserepairtalk.com/announcement.php?f=39&a=6"][size=3]The Ten Commandments of House Repair Talk[/size][/URL]



[URL="http://home.bellsouth.net/p/s/community.dll?ep=16&groupid=289528&ck="]Square Eye's home page[/URL]

RodgerBouter

Thanks for the tips guys!

Square Guy my problem is I have a solid slab foundation.

Should I anchor the wall into the slab?

Square Eye

Square tube steel.
Fast food places have this same thing to hold up tables and benches.
A 3" hole in the floor, a piece of 2"x2" steel square tubing.
The tubing can run as high as the knee wall framing.
Anchor it in the floor with cement mix or an epoxy patch mix.
Seal the bottom of the hole, seal the top of the tube..
or even better, fill it with cement after you get it bolted to the framing.
It won't move.

__________________
[URL="http://www.houserepairtalk.com/announcement.php?f=39&a=6"][size=3]The Ten Commandments of House Repair Talk[/size][/URL]



[URL="http://home.bellsouth.net/p/s/community.dll?ep=16&groupid=289528&ck="]Square Eye's home page[/URL]