DIY Home Improvement, Remodeling & Repair Forum > Appliances > HVAC > Compressor reset?





Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 06-19-2007, 02:12 PM  
shovelshort
Junior Member
 
shovelshort's Avatar
 
Join Date: Mar 2006
Posts: 15
Default Compressor reset?

Anyone know where the compressor reset switch is on a Lennox Value Series 10ACB36-11P air conditioning unit?

Here is what happened. I was outside and noticed (heard) the fan locked up on my unit. Not sure how long, but I don't think for very long. I shut down and took off the top. After turning everything back on, fan would not run. However, after getting it started with a finger, the fan would run. Compressor however, would not kick on and the obvious, no cool air in house. Everytime I restarted unit, I had to physically restart the fan by hand.

A buddy that does some HVAC work says the fan capacitor probably went bad and the compressor got hot, and the high pressure switch activated turning the unit off as a safety feature.

I plan on replacing the capacitor, but I can't find the switch on the compressor that he is speaking of.

The unit and freon levels where checked in the Spring by a paid service.

Thanks in advance.



__________________
shovelshort is offline  
 
Reply With Quote Quick reply to this message
Old 06-20-2007, 08:53 AM  
shovelshort
Junior Member
 
shovelshort's Avatar
 
Join Date: Mar 2006
Posts: 15
Default fan

Replaced the capacitor, connected everything according to diagram on inside of panel, and everything kicked on. The wiring connected to the terminals on the plastic box are black to black and orange to red. However, the fan is blowing air up and out. Not as I remember. The power/ground wires for fan don't seem as I remember either so I switched those and fan is now blowing down into unit (only after a kickstart with my finger).

Which direction should the fan be blowing? Is this thing wired backwards to begin with? Is my fan motor bad? How do I oil it and with what? Things don't make sense since this thing has been running fine for 7 years.

__________________
shovelshort is offline  
 
Reply With Quote Quick reply to this message
Old 06-21-2007, 12:31 PM  
glennjanie
Senior Member
 
Join Date: Mar 2006
Posts: 2,992
Liked 2 Times on 2 Posts

Send a message via AIM to glennjanie
Default

Hey Shovelshort:
There isn't a reset on the compressor; the hi-pressure switch is usually located outside the compressor and automatically resets within 5 to 10 minutes after the system shuts down. The pressure equalizes throughout the system when it is not running.
The fan is another problem. It may be seizing up or have a short in the start winding. In either case a new motor is the only cure. It was wise to try the capacitor first because it is far cheaper (there is a way to check a capacitor quickly and easily).
The motor is usually sealed and can't be oiled. It should blow up which draws air through the condenser coil picking up the heat and blowing it up and away from the unit.
Glenn

__________________
glennjanie is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On