DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   HVAC (http://www.houserepairtalk.com/f8/)
-   -   Connect Honeywell RTH8500 D Thermostat to Trane XE90 (http://www.houserepairtalk.com/f8/connect-honeywell-rth8500-d-thermostat-trane-xe90-12445/)

Fitmiss 11-02-2011 06:17 AM

Connect Honeywell RTH8500 D Thermostat to Trane XE90
 
I am a new home owner. I have removed the old standard Trane thermostat and replaced it with a Honeywell Programmable Thermostat RTH8500D. I believe I connected it correctly but the inside temperature is not matching the set temperature. I know the heater is on and have seen the pilot lit. I feel heat coming through the vents but my setpoint is 66 and the inside temp only registers 61.

There were 4 wires; red, white, yellow and green. I connected them to the corresponding colors (conventional heating/ac) on the new thermostat. I'm just wondering if I did something wrong. I don't believe I have a heat pump which is a different connection.

Question is why inside temp does not match setpoint after several hours even though heater is on? By the way, the filter is new and the red blinking light on the system is constant which I believe indicates the furnace is functioning correctly.

paul52446m 11-02-2011 05:17 PM

Connect Honeywell RTH8500 D Thermostat to Trane XE90
 
Quote:

Originally Posted by Fitmiss (Post 62907)
I am a new home owner. I have removed the old standard Trane thermostat and replaced it with a Honeywell Programmable Thermostat RTH8500D. I believe I connected it correctly but the inside temperature is not matching the set temperature. I know the heater is on and have seen the pilot lit. I feel heat coming through the vents but my setpoint is 66 and the inside temp only registers 61.

There were 4 wires; red, white, yellow and green. I connected them to the corresponding colors (conventional heating/ac) on the new thermostat. I'm just wondering if I did something wrong. I don't believe I have a heat pump which is a different connection.

Question is why inside temp does not match setpoint after several hours even though heater is on? By the way, the filter is new and the red blinking light on the system is constant which I believe indicates the furnace is functioning correctly.

don't know that stat, but read your instructions real close. On the back or inside the stat is there any small dip switch? These stats have to work on different systems so there is switches that have to be set for your system.
I now i had a least 4 Hon. round dial that were off 3 to 4 degrees, so i quit using that stat.
Anyway check real close and maybe some one will answer you that knows more about the stat you have. Paul


All times are GMT -6. The time now is 04:57 PM.