Kenmore Power Miser 80

Chaput87 · 10-27-2008, 07:19 PM

I have Kenmore Power Miser 80 (867768020) which I have already serviced myself a few times, but I am having trouble locating a part that Is starting to go bad.

It's the transformer that the vacumme switch, ignition system, and exhaust blower fan plug into.

I noticed when my furnace wasn't working so I went downstairs to the transformer humming and "stuck". It would not initialize the exhaust blower, which will not allow the furnace to start.

After cycling the furnace and whapping it a couple times, it works again. However, it did have to be whacked a couple extra times before it kept working and i'm not sure how much longer it will last.

The serial number I found on it was 882298 1003 OR H0607026HW (both are on it) and it it a Honeywell product.

I was not able to find a replacement anywhere on the web.

Suggestions?

kok328 · 10-28-2008, 09:04 AM

Are you looking for an electrical transformer?

look here: www.grainger.com

Square Eye · 10-28-2008, 10:19 AM

Transformer or contactor? Contactors will humm and stick... Not familiar with a transformer sticking..? If it's a contactor you should be able to get voltage values right on the part and replace it with a universal part.

Chaput87 · 11-18-2008, 05:44 PM

well....it only hummed once...when it was stuck. Other than that it clicks. It seems to be working ok now...it hadn't been used for a while.