DIY Home Improvement, Remodeling & Repair Forum > Appliances > HVAC > Need some help with sheet metal ductwork




Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 04-30-2011, 08:40 PM  
DrCharles
Junior Member
 
Join Date: Apr 2011
Location: West Plains, MO
Posts: 2
Default Need some help with sheet metal ductwork

New to this board, and to ducts... I've been doing my own electrical wiring and some plumbing for a long time, but have no experience with ductwork. My 6BR, 4BA house HVAC is, to put it mildly, a mess. There is a wood furnace, and also a gas furnace and older Carrier a/c. Two manually operated dampers on the output plenums select which system is in use. The intakes are both connected to the return duct, but badly. There are four small returns scattered almost at random. See the pictures

Recently I started to remove the tub and floor in one of the bathrooms to fix soft spots. Among other interesting "fixes", when central heat/ac had been installed, to make room for a small return in the hallway they cut the joist (that ran directly under the tub, naturally) and set each end on cinderblocks directly on the dirt crawlspace. Having no codes/inspections is a mixed blessing... but I digress.

Anyhow, in order to structurally repair the floor and reinstall the joist properly, I had to remove that return duct. I now want to have one large return, with a filtered grille, in the wall at the end of the main hallway. Behind that wall is a walk-in closet, and it's nearly a straight drop through the closet floor to the return duct. To start with, I need a grille and filter assembly, preferably 14" wide or less, so that it will fit between the studs without framing an opening. I was thinking of a 25x14 mounted with the long dimension vertical.

But then I need to connect to the duct passing through the floor, which means a 90 degree elbow. Is this something I'll have to make from sheetmetal, or is there a standard piece that I can buy?

It would not be too much more trouble to frame in a horizontal opening in the wall in order to mount the 25x14 horizontally. Once I get it into the basement I'll worry about how to connect it to the return trunk next...

When the return is functional I'll attack the supply ducts next. Any tips and tricks greatly appreciated. There are few contractors in my area, I don't know how qualified they are, and I would rather learn and do it myself while saving money...
thanks
Charles



p4290031.jpg   p4290032.jpg   p4290033.jpg  
__________________
DrCharles is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter DIY Home Repair Forum Replies Last Post
metal roof sheet problem scotlad Roofing and Siding 14 02-23-2011 10:55 AM
Tarkett glueless vinyl sheet. Junk? Quattro Flooring 1 08-30-2009 09:18 PM
Ductwork txgrl74 HVAC 7 09-10-2007 11:06 AM
Removing vinyl sheet flooring WestBentley Flooring 6 03-30-2007 06:17 PM
Ductwork Mysteries cboley4 Introductions 2 03-25-2007 10:39 PM