DIY Home Improvement, Remodeling & Repair Forum > DIY Home Improvement > Electrical and Wiring > door alarm contacts





Reply
 
LinkBack Thread Tools Search this Thread Display Modes
Old 12-03-2005, 01:45 PM  
jackster
Junior Member
 
Join Date: Dec 2005
Posts: 1
Default door alarm contacts

My Problem Is The Front Door Contact, It Wont Set The Alarm When Exiting The Home, If I Take The Switch Apart And Touch The Wires And Set The Alarm Then Take Them Apart It Works, Same When Entering Pulling The Wires Apart It Gives Off The Bleeping As It Should, But Put It All Back Together And It Fails Again, I Really Need Answers Asap Please . Thanks



__________________
jackster is offline  
 
Reply With Quote Quick reply to this message
Old 01-13-2006, 07:34 PM  
PaulJ
Junior Member
 
Join Date: Jan 2006
Posts: 7
Default

Did you install the system yourself? If not you might call the security company that installed it and have them come out and check it. They should do it free of charge.



__________________
PaulJ is offline  
 
Reply With Quote Quick reply to this message
Old 02-11-2008, 11:21 AM  
Home Alarm Specialist
Junior Member
 
Join Date: Feb 2008
Posts: 2
Default Home Alarm Door Sensors

It could be faulty wiring or a bad sensor. It could also be a problem with installation. Is it embedded in the door? The door sensor itself could be pushed to far into the hole. It could also be a problem with the door alignment not matching up perfectly. Many times, dark doors can warp slightly from the heat over the years. If it is an old system this may be the case.

Either way I would highly suggest having a professional out to take a look. Doors are the primary point of entry for burglars and you need your monitoring to be right on point.

__________________

Bruce Kelly - [URL="http://www.securitychoice.com/"]Home Alarm[/URL] Specialist

---- Be safe ----

Home Alarm Specialist is offline  
 
Reply With Quote Quick reply to this message
Old 02-12-2008, 05:55 AM  
CraigFL
Senior Member
 
Join Date: Mar 2006
Posts: 409
Default

First, I'm assuming this is the little pushbutton switch that's activitated by the door jam pushing on it. I've seen some of those switches become faulty and actually can be pushed too far in. In other words, with the switch pushbutton all the way out, the switch is OPEN. When you push the button in, the switch is CLOSED. But, if you push the button in even farther, the swich goes to OPEN again and therefore the alarm system can't be set. This may be happening because there is so little clearance in most door jams that the switch is pushed in too far. Personally, I would just replace this switch with a new one since they are not expensive. Trying to repair it will just be aggravating because it may not work consistantly.

P.S. I hate it when people resurrect old posts!

__________________
CraigFL is offline  
 
Reply With Quote Quick reply to this message
Reply


Quick Reply
Message:
Options

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are On
Refbacks are On