DIY Home Improvement, Remodeling & Repair Forum

DIY Home Improvement, Remodeling & Repair Forum (http://www.houserepairtalk.com/forum.php)
-   Electrical and Wiring (http://www.houserepairtalk.com/f9/)
-   -   Torque on exterior A/C disconnect lugs (http://www.houserepairtalk.com/f9/torque-exterior-c-disconnect-lugs-16067/)

suobs 06-02-2013 06:53 AM

Torque on exterior A/C disconnect lugs
 
I am redoing the wiring to an exterior A/C compressor and to/from the exterior disconnect box (made by GE). The disconnect box instructions say to torque the lugs to 32-35 in-lb. I've ruined several lugs trying to do this. They have a single slot that is so wide that I can't find any driver bit that engages the slot securely, definitely not enough to accommodate that kind of torque. Is there a special tool for this or am I missing some trick of the trade? Also, should I be using a torque wrench also on the connections to the A/C?

kok328 06-02-2013 07:02 AM

as tight as you can get them with a regular screwdriver is fine.

suobs 06-02-2013 07:35 AM

One more question about this - I assume that for the lug connections you strip off enough insulation (about 1/4"-3/8") to inert the bare wire under the lug, then just tighten the lug down on it. In other words, the wire doesn't wrap around anything, right?

(I can't believe manufacturers can get away with being so vague about something that is supposedly critical - the instructions actually say to strip off "__ in" (direct quote - there's no number there) of insulation and they included no illustration of the lug connection).

CallMeVilla 06-02-2013 08:02 AM

1 Attachment(s)
You are correct. The insulation should not be trapped inside the lug AND there should be about
1/4" of bare wire between the lug and the insulation. Common sense: minimize the exposure of the conductor and prevent the insulation from getting fried at the connection point.

You are doing fine. Get it done so you can go inside and have a cool drink. :D

suobs 06-02-2013 08:31 AM

Sun's not on that wall yet, so I'm good :rolleyes:.

Thanks for the photo.


All times are GMT -6. The time now is 07:27 PM.