VIEW MY

RedBaron

Gift Premium Subscription To RedBaron

Join Date:

03-17-2013

Last Activity:

03-29-2014 10:29 AM

Likes Given: 3

1 Likes on 1 Posts 

LATEST ACTIVITY

  • Posted in thread: Roof leak, Exhaust vent for bathroom fan on 03-29-2014 at 10:05 AM
    Ice forms about 6" below the vent on top of the shingles. Pipe is about as short as you can get
    and fan is slightly closer to the centre of the house. Vent is at a very low part of the attic
    so the bl...

  • Posted in thread: Roof leak, Exhaust vent for bathroom fan on 03-28-2014 at 07:05 PM
    The last two years I have had water come in due to ice damming under the roof vent from the
    bathroom exhaust fan. I looked all over the internet and can't seem to find anything on how to
    prevent this....

  • Posted in thread: Framing Wall - Poor Workmanship or Acceptable Practise on 02-22-2014 at 11:02 AM
    Here is another thing I have a problem with . I can't see this being acceptable. But would like
    to know what others thinkThis is the same house. The window was put in the wrong place and I
    told them t...

  • Posted in thread: Framing Wall - Poor Workmanship or Acceptable Practise on 02-11-2014 at 05:02 PM
    First off thanks for all the information helps when dealing with the builderAnother question
    how high above the door should a header be or better question how high is it allowed to be over
    the door? P...

  • Posted in thread: Framing Wall - Poor Workmanship or Acceptable Practise on 02-10-2014 at 07:17 PM
    Don't have many pictures but here is one from a few days earlier. That small section between
    joists is just covered with a thin strip of OSB only crossing those two studs. There is a
    bedroom over the ...

  • Posted in thread: Framing Wall - Poor Workmanship or Acceptable Practise on 02-09-2014 at 08:24 PM
    Not really worried about an extra stud but the drywall seams won't work out since 16" centres
    won't carry down the wall. Plus it's more a question on workmanship. I think its poor
    workmanship I want t...

  • Posted in thread: Framing Wall - Poor Workmanship or Acceptable Practise on 02-09-2014 at 06:30 PM
    I have a new house being built and I think the framing on the garage wall is poorly done. When
    complaining I was told by the developer that nobody guarantees 16" on centre studs. Which is
    fine due to ...

  • Posted in thread: Frost on top of foundation on 01-12-2014 at 07:37 AM
    By looking and feeling around I can't seem to find any evidence of sill sealer, house was built
    in the 1974 don't know what they used back then or if they even did that back then. The
    driveway is righ...

  • Posted in thread: Frost on top of foundation on 01-09-2014 at 09:10 PM
    There is fibreglass insulation (Roxul) stuffed in all the joist spaces vapour barrier carriers
    up from behind the drywall and covers the insulation. It is exactly the same through out the
    entire basem...

  • Posted in thread: Frost on top of foundation on 01-09-2014 at 07:00 PM
    I have frost on the top of my foundation wall in the basement. I have read some things about
    using a spray foam to get rid of this, which is what I probably will do. I just can't figure
    out what cause...

0 COMMENTS
POST A COMMENT