Last Activity:05-26-2008 8:50 AM
Posted in thread: gas stove, 2 burners won't lite on 04-16-2008 at 11:23 AM
If the electrode that is next to the burner is sparking when you turn on the burner check to
make sure that the tip of it is clean.Can you supply the model number of your range?You can
find the model ...
Posted in thread: over the counter microwave?? on 03-28-2008 at 12:15 PM
As long as the air can circulate around the microwave it should work just fine.Some microwave
are called space savers and are mounted on the bottom of the top cupboards. These type are not
Posted in thread: Opinions on Admiral brand on 03-24-2008 at 12:46 PM
Admiral has been around for years.More then likely made by Whirlpool.Just look on the model
number tag it will have the manufacture on it.
Posted in thread: fridge help on 03-24-2008 at 12:43 PM
If the fridge was low on freon it would not work properly so I don't think it needs to be
charge unless you have a cooling issue also.Does it sound more like a vibrating noise?It could
be age related.
Posted in thread: Is my dishwasher dead? on 03-24-2008 at 12:18 PM
If the dishwasher start filling when it was off you will need a new fill valve.There should be
a shut off valve under the sink to shut the water off to the dishwasher.A new valve for the
Posted in thread: Frigidaire electric stove element malfunction on 03-20-2008 at 12:00 PM
Even if your top does not lift up there should only be one screw holding the receptacle in
place.A lot of the replacement receptacle come with Marr connector so you don't have to run the
wire to the s...
Posted in thread: Stove Racks on 03-20-2008 at 11:46 AM
If you still have not got a rack for your oven take the model number and call a local parts
dealer or you can get your Appliance parts here.The model number should be on the frame of the
range where t...
Posted in thread: Gas Stove needs a new gas tube for oven on 03-20-2008 at 11:16 AM
Hi AnevitteDoes the schematic have any type of part number on it?Is the tube you are looking
for Is it for the oven burner?Can you describe your range a little more?Is there a back splash
with a light...
Posted in thread: Moldy water line in fridge on 03-18-2008 at 11:59 AM
If it is in the coil behind the crisper it can be replace.
Posted in thread: Clothes Gas Dryer not heating on 03-18-2008 at 11:34 AM
Make sure you unplug the dryer before you do any testing.To check the igniter you will need an
ohm meter.You should have a reading 50 and 500 ohms.You can also test the valve.On the three
pin valve yo...