Back40

LATEST ACTIVITY

• Posted in thread: Concrete flooring over wooden subfloor? on 06-07-2013 at 10:34 AM
  Great feedback folks! Thanks again.

• Posted in thread: Concrete flooring over wooden subfloor? on 06-06-2013 at 10:27 AM
  Sounds like a slab foundation would be the way to go but then I would be concerned about
  addressing any potential plumbing issues in the future.

• Posted in thread: Concrete flooring over wooden subfloor? on 06-05-2013 at 11:21 AM
  Thanks again for everyones feedback!

• Posted in thread: Concrete flooring over wooden subfloor? on 06-04-2013 at 11:22 AM
  I am considering concrete flooring in a new single story home. I am leaning to having a crawl
  space vs slab and was wondering if a standard wooden subfloor/joists would support a concrete
  floor? Thank...

• Posted in thread: GE Dryer (model DBXR463ED2WW) does not cycle to lower temp on 11-22-2011 at 04:54 AM
  Hi Jeff, I described the problem incorrectly. The dryer drys at a high temp even when the temp
  selector is set to a low temp.

• Posted in thread: GE Dryer (model DBXR463ED2WW) does not cycle to lower temp on 11-21-2011 at 02:44 PM
  My GE dryer (model DBXR463ED2WW) drys at a high temp even when the temp selector is set to a
  low temp. Is this a thermostat prob? I have searched and found a high limit thermo and cycling
  thermo. Do I...

• Posted in thread: Fluidmaster value turns on/off, flush valve is new also. on 11-15-2011 at 06:50 AM
  Dye (blue) test on both toilets resulted in light blue water in bowls, so I'll be replacing the
  flappers next. Question about flapper design/fit, should part of flapper that protrudes into
  the water o...

• Posted in thread: Fluidmaster value turns on/off, flush valve is new also. on 11-14-2011 at 05:23 AM
  Have not done the dye test yet but plan to. I did use the clip to attach the refill tube to the
  overflow pipe so no siphoning is taking place.

• Posted in thread: Fluidmaster value turns on/off, flush valve is new also. on 11-11-2011 at 11:31 AM
  There's a plastic coller around the shaft where the unit mounts to the tank it needs to be
  adjusted. you referring to adjusting the height of the fill value unit vertically? I have it
  mounted so that...

• Posted in thread: Fluidmaster value turns on/off, flush valve is new also. on 11-10-2011 at 06:04 AM
  I recently (2 months) replaced both fill and flush valves in 2 toilets with Fluidmaster
  products. A week ago I noticed both toilets fill valves are turning on even though the water
  level in the tank i...