Last Activity:03-04-2011 8:28 AM
Posted in thread: Conversion from Direct to Indirect DHW heating...better pressure? on 03-02-2011 at 09:23 AM
Hi-Our house was built in 2004 and has a Direct Tankless/Coil Oil Boiler that supplies both
Domestic Hot Water (DHW) as well as runs the hydronic baseboard heating system.We've seen the
Posted in thread: Could wire be bad? on 10-18-2010 at 02:41 PM
Thanks for checking in and yes I did solve the problem....turns out a severe storm caused the
light fixtures to be damaged so it wasn't a problem with the wire/switch at all. It was also
hard to diagn...
Posted in thread: Could wire be bad? on 10-03-2010 at 11:13 AM
I'm checking the voltage with a light-tester and not a DVM, checking it from hot to neutral.On
second thought, Is it possible that the the switch is bad but there is enough voltage for the
Posted in thread: Could wire be bad? on 10-02-2010 at 10:55 AM
Thanks for the quick response. Unfortunately, I think its something else than either a break
under a wire nut or a bad switch.The only place where there are wire nuts (that i know of) is
at the light ...
Posted in thread: Could wire be bad? on 10-02-2010 at 09:55 AM
Hi everyone;I'm trying to track down the solution to an electrical problem and not having much
luck.We have two exterior lights on the front of the garage that stopped working recently.
Thinking they ...
Posted in thread: Driveway repairs on 07-15-2010 at 01:18 PM
Hi everyone;I know little/nothing about asphalt, other than my driveway needs some help!Our
driveway went in in 2004 when they built the house, and the pavers only laid the base-coat at
the time. We a...
Posted in thread: Finishing basement, mildew on stored items. on 10-01-2009 at 10:23 AM
Hi everyone;We are starting on our project to finish off the basement and trying to determine
if we have a moisture problem and how to remedy it (if necessary).This is what we have: House
built in 200...
Posted in thread: Generator Cord and Inlet box 20A to 30A on 04-23-2009 at 07:49 AM
Thanks for everyone's input. My plan for transferring the load into the circuit box is to have
a manual transfer box at my circuit breaker panels with a line running from the transfer box
out to the i...
Posted in thread: Generator Cord and Inlet box 20A to 30A on 04-22-2009 at 01:14 PM
The generator I have has 4 120V outlets and a 120/240V 30A outlet.
Posted in thread: Basement remodel, Adding Bedroom, Using Bulkhead as Egress? on 04-22-2009 at 09:11 AM
Hello All,We are contemplating finishing off half of our basement and leaving the other half
unfinished for a small workshop. We would like to put a bedroom, a small bathroom, and a TV
room as part of...
- No Water Running Into or Out of Toilet
- Need some advice
- Carrier AC Outside Fan Will Not Turn ON
- fan wont shut off
- genie isd 990 excelerator will not stay on
- Exhaust Fan In Bathroom
- Need some help
- drylocking basement and removing mold on concrete
- One Word Game
- Flashing problem?
- Lawnmower Question
- Size of intake vent?
- Hall Way Door - Is this load bearing?
- Hallway header options where door is
- Granite Installed - Possible Issue?
- Install Quarter Round when there is large gap underneath the baseboard?