Last Activity:02-03-2012 8:48 PM
Posted in thread: New welder outlet wiring on 01-23-2012 at 05:50 PM
alaska, good ideas. I have not heard from Miller after two emails. The power numbers come from
Millers specs. Why the strange plug I have no idea but it may come from the fact that this
welder can wor...
Posted in thread: New welder outlet wiring on 01-20-2012 at 10:27 PM
No way I am going to void the 3 year warranty on a new welder by changing the plug called for
by the maker.
Posted in thread: New welder outlet wiring on 01-19-2012 at 07:08 PM
The plug is called for by Miller but the mig uses less than 30 amps.
Posted in thread: New welder outlet wiring on 01-18-2012 at 04:07 PM
Wire from box to outlet is 10 gauge. I have received dif ideas on the white wire vs the ground
wire to the third prong. Will not change end from welder as it is new with warranty.
Posted in thread: New welder outlet wiring on 01-01-2012 at 02:10 AM
Will check wires at panel Sunday.
Posted in thread: New welder outlet wiring on 12-31-2011 at 06:08 AM
My shop was wired years ago for 220 but no outlet was installed. I have black, red, white and
green wires in box. The outlet called for by Miller is NEMA type 6-50 that has 3 connections
with 1 marked...
Posted in thread: Correct insulation install in crawl space floor joists on 01-04-2011 at 02:01 AM
What is your location?
Posted in thread: OK to blow cellulose over blown fiberglass? on 12-22-2010 at 08:32 PM
No way will I remove the old stuff. Will install baffles for sofit vents and have ridge vent
now. Just planning to blow cellulose on top of the fiberglass. The access to this area is
Posted in thread: OK to blow cellulose over blown fiberglass? on 12-13-2010 at 04:00 PM
My access to 1/2 of my attic is thru a 1' by 2' hatch in a second story closet. The blown
fiberglass is full of mice holes and acorns and is thin(2-4"). The freeloaders have been
evicted. The area is ...
Posted in thread: Insulation Advice on 12-13-2010 at 03:19 PM
I would be careful about insulating the floor with fiberglass in N.O. In SC it tends to hold
moisture and provides living area for mice.
- Garage door opener just barks at me!
- Possible mold problems??
- One Word Game
- drylocking basement and removing mold on concrete
- Fire Safety
- Your house is how old?
- Eliminating Drywall Ceiling In Attached Garage
- backyard improvements
- Dishwasher not draining completely
- Musky smelling rugs
- Getting rid of mosquitos
- Ice Maker not working
- Small cabin help..?
- Installing new garbage disposal
- Lawnmower Question