Last Activity:01-22-2017 10:42 PM
Likes Given: 118
43 Likes on 37 Posts
Posted in thread: Chris on 01-19-2017 at 03:39 PM
Sure is nice getting out at 330 and not thinking about a thing until 7am . I tried starting my
own thing when I was younger . The long nights and the complaining customers and the battles to
get my mo...
Posted in thread: Anybody know about backhoes? on 01-19-2017 at 03:32 PM
https://buffalo.craigslist.org/hvo/5930668708.htmlWhat about JCB ? Guy says the meter went out
this summer , and had 3500hrs .
Posted in thread: Hvac Rectangular Stack Inside Wall on 01-11-2017 at 08:11 AM
I am no pro on this stuff but look at your photo, the oval is 3 1/2 deep and there is a half
inch in the front where it can come thru the drywall, what are you supposed to do with the half
inch in the...
Posted in thread: Hvac Rectangular Stack Inside Wall on 01-02-2017 at 08:22 PM
In that case your right , 10x easier . But then you need to duct it through the wall to the
grill or else it blows into the wall . Not sure if that would cause a problem blowing any air
into the wall ...
Posted in thread: Help with drywall and trim around new doors and windows on 01-02-2017 at 08:14 PM
Ok so the door will wait till warmer weather as I need to adjust it . So next , windows . This
window is new construction nail flange . It has jambs , but way to short . I replaced the
window after dr...
Posted in thread: Hvac Rectangular Stack Inside Wall on 01-02-2017 at 08:04 PM
I am planning on installing ceramic tiles in the new future, and since it is a slab there would
be no backerboard. Baseboard: I don't know exactly but it should be basic type on the short
Posted in thread: Hvac Rectangular Stack Inside Wall on 01-02-2017 at 08:02 PM
Ovals are nice but every time I have had to work on them, I have had to get the boot made,
nobody has a pattern for it..Hey friend ! Really , pretty common here . Not that I would buy
from the depot ,...
Posted in thread: Hvac Rectangular Stack Inside Wall on 01-01-2017 at 06:31 PM
As far as height , what's the floor going to be ? Carpet / hardwood ect , and how deep will it
be ? Figure your grill on the wall will be an inch lower than the square opening . How tall is
your trim ...
Posted in thread: Cast Iron Drain Problem on 12-31-2016 at 05:10 PM
I used jb weld on my beater plow truck . The oil filter housing rusted and cracked where the
filter gasket mates , cleaned it real good with degreaser, jbwelded it , sanded it flat. Good
as new .....w...
Posted in thread: Help with drywall and trim around new doors and windows on 12-31-2016 at 04:33 PM
I get how being racked can do this , but how is it the the top and bottom do this equally while
the middle is fine ? I did the whole tweaking thing and used shims to get it to close right .
It had a t...