VIEW MY

clemkonan

Gift Premium Subscription To clemkonan

Join Date:

09-05-2006

Last Activity:

04-02-2009 3:31 PM

LATEST ACTIVITY

  • Posted in thread: Dirty Dishes New Dishwasher on 04-02-2009 at 02:31 PM
    I traded in the old dishwasher for a Kitchen Aid Serial # FW4305915 and the results were
    dramatic. I got a quiet cycle with a fraction of the insulation and clean dishes and glasses to
    boot. This was ...

  • Posted in thread: Pocket Door on 11-14-2008 at 11:51 AM
    I will come over and check that out but here in Toronto that sucker is $199 and the door about
    $85

  • Posted in thread: How to Move a Hot Water Heater on 11-14-2008 at 11:48 AM
    Just to clarify the line drop drops down form the ceiling at a 90 degree angle off the main
    line, that length is say 5 feet then it meets the shutoff and a union. Next there is a short
    elbow over to t...

  • Posted in thread: How to Move a Hot Water Heater on 11-06-2008 at 11:27 AM
    My hot water heater (gas) is located so that I cannot get by it to get to the rest of the room.
    To date we have been using a cut out in an adjacent room ( my office) which is now going to
    become a lau...

  • Posted in thread: Pocket Door on 11-06-2008 at 11:02 AM
    I need to create a neat entrance from my basement laundry room to the adjacent furnace room so
    that I can service my furnace periodically. There is a furnace door or opening but it is
    clocked off by t...

  • Posted in thread: Laminate Floor and Stair Spindles on 09-06-2006 at 08:26 PM
    I think I get the idea however I will try to check out a couple of model homes to get a visual
    picture. Thanks again

  • Posted in thread: Solar Tubes on 09-06-2006 at 08:11 PM
    Thanks very much I will plan this for next spring, the chill is soon coming to the True North.

  • Posted in thread: Solar Tubes on 09-05-2006 at 12:54 PM
    I saw a skylight in a new homes which resulted in an Internet search that introduced me to
    skytubes. In case I am not describing this product properly I am referring to an alternative
    involving a rigi...

  • Posted in thread: Laminate Floor and Stair Spindles on 09-05-2006 at 12:46 PM
    Hello everyone I am brand new to the forum. My goal is to learn as much as I can and share what
    little experience I have. I am not much of a DIY but the high cost of labour demands that we
    all try to ...

0 COMMENTS
POST A COMMENT