Last Activity:05-15-2013 3:54 PM
4 Likes on 3 Posts
Posted in thread: Weed Trimmer, Runs in START, dies in RUN on 05-08-2013 at 05:57 AM
Well, that's the easy way... This is what the screwdriver looks like
Posted in thread: Weed Trimmer, Runs in START, dies in RUN on 05-07-2013 at 06:11 AM
The problem with the pliers is the screws are countersunk into the body of the carburetor. The
screws go through a nylon plug moulded into the carb to keep them tight ant that makes it
Posted in thread: Weed Trimmer, Runs in START, dies in RUN on 05-04-2013 at 10:47 AM
no... Poulan used a splined screw for a while... more like a 4mm double square screw. I can't
think if there's an alternative that a homeowner might have... Poulan was bought by "Electrolux
Posted in thread: One Word Game on 05-03-2013 at 07:34 PM
Posted in thread: Weed Trimmer, Runs in START, dies in RUN on 05-02-2013 at 05:00 PM
if you replaced the carburetor, odds are it's not adjusted correctly. if it has 2 adjustment
screws (marked H and L) gently turn them in all the way and then out 1 1/2 turns each. warm the
engine up f...
Posted in thread: lawn care on 05-02-2013 at 04:53 PM
Best bet is "Par 3" then overseed.
Posted in thread: ABS Pipe vs Air compressor? on 05-01-2013 at 06:07 PM
Success. Took about 30 psi
Posted in thread: ABS Pipe vs Air compressor? on 05-01-2013 at 05:15 PM
I thought about the snake... the plumbing in my house was done by M. C. Escher, and has too
many bends than is necessary, and probably travels about 40' before it even leaves the house
Posted in thread: ABS Pipe vs Air compressor? on 05-01-2013 at 07:58 AM
My sump-pump hose runs about 8" below grade for a distance of 30'. either it's frozen or
plugged with debris.If I brew-up some type of fitting, and connect my air compressor to the ABS
pipe inside the...
Posted in thread: Best faucet??? on 05-01-2013 at 07:53 AM
Hate to be "that guy" but they're all the same. It really comes down to looks. unless you are
planning to spend $250+ on a kitchen faucet (I own a Kohler) you are going to get the same
warranty and qu...
Over budget and behind schedule...
That's how I roll
- One Word Game
- Best way to get rid of dandelions from the yard
- Aggressive Deer
- Excel Workbook
- Bad block foundation options
- Possible mold problems??
- Installing new garbage disposal
- question about water from central a/c
- deck roof and gutter question
- A little help with hardware, please?
- Suggestions on how to repair
- Crumbling, 'spaling' exterior foundation walls
- pressure washer advice
- Toilet will not fill