diyguy1971

LATEST ACTIVITY

• Posted in thread: Old to New and no fun trying to get there on 02-14-2012 at 06:50 PM
  Redwood,Was a clogged line causing the backup. The line is 2" Cast and I did end up cutting the
  hub off and used the boot as suggested and added a trap. I installed a pro-Vent on the drain
  line about ...

• Posted in thread: Old to New and no fun trying to get there on 02-05-2012 at 09:45 PM
  small update, Tried sealing the washer drain into the drain pipe temporarily and ran a low
  setting of water through. Upon Spin cycle, water was being pumped up into the kitchen sink.

• Posted in thread: Old to New and no fun trying to get there on 02-05-2012 at 08:11 PM
  Got a little sleep and made it through work and am back at it... I ended up breaking up the
  slab floor beyond the hub and removed the entire hub and stuck pipe giving me a clean 2" Dia
  pipe to put a b...

• Posted in thread: Old to New and no fun trying to get there on 02-04-2012 at 09:13 PM
  Ok, I tried my best to have no spelling errors in that last...I give...Goodnight and I'll read
  this when I get up for work... Hope somone can give me a few pointers..... Thanks in advance
  for any repl...

• Posted in thread: Old to New and no fun trying to get there on 02-04-2012 at 09:10 PM
  Been studying my perdicument and am considering cutting the line just after the union and boot
  from there. The only bad point in this is that the union is resting directly below a wall. I
  would probab...

• Posted in thread: Old to New and no fun trying to get there on 02-04-2012 at 08:18 PM
  Hi All from Indiana! Have a problem with a remodel thats kicking my butt and would like to ask
  for anyones suggestions. I am adding a laundry room and it is being built in what was once an
  attached ga...