VIEW MY

doechsli

Gift Premium Subscription To doechsli

Join Date:

05-29-2012

Last Activity:

09-23-2016 11:15 AM

Likes Given: 6

14 Likes on 9 Posts 

LATEST ACTIVITY

  • Posted in thread: Replacement heater wiring problem on 09-20-2016 at 05:52 AM
    My limited knowledge would think there should be three leads (2 hots and a neutral) and a
    ground for 220V not just two and a ground.

  • Posted in thread: Thermostat clicks but nothing happens on 09-16-2016 at 11:20 AM
    The cap is located on the outside unit. Troubleshooting is problematic unless you have the
    correct meter however the caps are fairly inexpensive (20-40 bucks) and not too difficult to
    change. That sai...

  • Posted in thread: Thermostat clicks but nothing happens on 09-16-2016 at 10:47 AM
    I would say a starter cap, but I believe the furnace/air handler fan would run regardless of a
    cap failure. I just had one of these failures this year.Another question is the "light switch"
    to control...

  • Posted in thread: refinishing pine floors on 09-08-2016 at 08:13 AM
    I'm not sure I would putty anything but nail/knot holes. The old boards will flex up and down
    independently as it is walked on. I would expect putty to crack. I freely admit I am not a
    floor expert, b...

  • Posted in thread: Glass for master bath shower? on 09-05-2016 at 08:31 PM
    I ripped my tub and put in a walk in shower. I put in custom cut rimless clear glass and love
    it. I treat the glass with RAIN-X and we use liquid soap which leaves no soap scum so it's not
    a clean up ...

  • Posted in thread: Odd Sized Bathroom Vanity on 08-26-2016 at 08:16 AM
    I had a very oddly configured bathroom and my contractor built my vanity to fit the space. It
    worked out beautifully and was only slightly more expensive than a "stock" vanity. We were
    doing a granite...

  • Posted in thread: Need Some Ideas - Aggregate Patio Seams on 08-20-2016 at 09:29 AM
    Will polymeric sand be able to handle gaps as wide as an inch?

  • Posted in thread: Need Some Ideas - Aggregate Patio Seams on 08-19-2016 at 02:21 PM
    I have a washed aggregate patio that was installed 35+ years ago. It is in remarkably good
    shape with very few cracks. The patio was poured in diamond shaped sections with what I believe
    was 1x4 lumbe...

  • Posted in thread: Some pics of what I do. on 07-13-2015 at 07:55 AM
    I had a sewer line replaced a while back and the trench was 9 feet deep at one end and the
    plumber/excavator NEVER shored the walls. I asked if that wasn't a bad idea and he said it
    wasn't required. I...

  • Posted in thread: Need advice on damage due to sump pump water on 05-20-2015 at 09:34 AM
    I think a landscaper would be a better choice than a lawn care specialist. Sketch out what you
    want and get several bids.....and get it in writing.

FORUM SIGNATURE
Dennis
0 COMMENTS
POST A COMMENT