Gift Premium Subscription To elbo

Join Date:


Last Activity:

10-06-2015 9:00 AM

Referrals: 1

Likes Given: 27

43 Likes on 36 Posts 


  • metalwork, woodwork, horticulture, computers, fishing,
  • retired
  • male
  • florida


  • Posted in thread: Repairing cutting board on 10-06-2015 at 03:35 AM
    I would clean the old glue off, put the pieces together with either dowels or biscuits, and
    glue with epoxy. I'm not sure if the wood glues are toxic or not, but I know that cured epoxy
    is true neutra...

  • Posted in thread: Refinish antique on 09-22-2015 at 11:40 AM
    I've never used it, but if I did, I would have followed the directions, and if I still had
    questions, I would contact the mfgr.

  • Posted in thread: Dead bees near air condition outlets on 09-18-2015 at 01:48 PM
    I bet if you are able to find a bee keeper, he would be able to find the source and even remove
    the bees for you

  • Posted in thread: Traffic on 09-15-2015 at 10:17 AM
    Here where I live ( ((slo )) cala florida, where there is a high amount of elderly old Fa*ts ,
    who think that the posted speed limit is really too fast, after all, they know more than the
    people who s...

  • Posted in thread: Toilet leaked for a week, now stopped, do I still have a problem? on 09-15-2015 at 09:59 AM
    are you sure it's not condensation. If the water is cold and the room is humid, you will get
    what appears to be a leak. If it is condensation, and it bothers you, you could get a low
    wattage submersib...

  • Posted in thread: Refinish antique on 09-14-2015 at 10:30 AM
    is your hand steady enough, is your eyes good enough, is your hand / eye coordination good
    enough to make the circle of tape absolutely true ? If your answer is no, then you are going to
    screw it up r...

  • Posted in thread: Refinish antique on 09-13-2015 at 12:32 PM
    given its presumed age, I wouldn't sand or strip the table. I would get a good wood cleaner ( I
    believe that Formby's makes one ) and clean all the crud that built up over the years, then
    touch up any...

  • Posted in thread: squirels and electricity on 09-06-2015 at 11:30 AM
    I think several of you misunderstood me, I would wrap wires connected to the charger around the
    outside of the rubber insulation. There would be no contact with anything directly connected to
    the a/c ...

  • Posted in thread: squirels and electricity on 09-05-2015 at 10:16 AM
    c'mon guys. I just want to know if 24 volt and 400 MA is too much. I already know how to do it
    at very little expense or labor. If the voltage and amp aren't too much for a squirrel, then it
    wouldn't ...

  • Posted in thread: squirels and electricity on 09-04-2015 at 02:24 PM
    that will work,until it rains, and/or, I remember to reapply it. I'd rather give them a little
    goose that will require no attention from me


Newest Threads