VIEW MY

InTooDeep

Gift Premium Subscription To InTooDeep

Join Date:

03-04-2014

Last Activity:

07-29-2014 10:30 AM

LATEST ACTIVITY

  • Posted in thread: Does a 240v dryer plug need to be GFCI? on 07-26-2014 at 10:27 AM
    So dryer outlets are automatically hooked up to prevent ground faults?

  • Posted in thread: Does a 240v dryer plug need to be GFCI? on 07-26-2014 at 07:07 AM
    My laundry room right now is setup with the washer beside the dryer and then a laundry sink
    beside the dryer. I've been researching whether this is a problem having a sink close to a 240v
    outlet but c...

  • Posted in thread: How do I know if my basement is insulated? on 06-20-2014 at 06:34 PM
    Well it's darker along the bottom. But it's not mushy. Just about as solid as the rest studs.

  • Posted in thread: How do I know if my basement is insulated? on 06-20-2014 at 06:13 PM
    Well unfortunately the walls are already framed so I can't put anything under the bottom 2x4.
    So just to be clear the foam board doesn't require a plastic vapor barrier over it correct?

  • Posted in thread: How do I know if my basement is insulated? on 06-20-2014 at 05:00 PM
    So I've decided I'm going to rip down the walls and insulate the rimjoists and put up a vapour
    barrier. The basement is going to a living area and it's important that it stays warm during
    the winter. ...

  • Posted in thread: How do I know if my basement is insulated? on 06-19-2014 at 07:20 AM
    I found a bit of black wood along the floor. Everywhere else seems fine. I do plan to have the
    basement as a living space. So I'm worried that I won't be able to keep it warm in the winter.
    I live in ...

  • Posted in thread: How do I know if my basement is insulated? on 06-18-2014 at 07:02 PM
    Thanks for all the replies. Follow up question. I ended up opening some more walls only to find
    that there was pink insulation but no vapor barrier (no plastic film or tar paper). Is a vapor
    barrier n...

  • Posted in thread: Cutting a Laminate Countertop on 06-16-2014 at 02:39 PM
    So took your advice (cut with a skilsaw and then sanded down to a clean finish). Turned out
    pretty well. You really have to look close to see any imperfections. Anyway I'm currently
    putting on the end...

  • Posted in thread: Cutting a Laminate Countertop on 06-09-2014 at 04:14 PM
    I have a laminate countertop I need to be cut for my bathroom vanity. I obviously need to cut
    this straight and without burrs. I tried using a jigsaw with painters tape but it didn't turn
    out that wel...

  • Posted in thread: How do I know if my basement is insulated? on 05-16-2014 at 07:28 PM
    I have a brick exterior, can this still be done?

0 COMMENTS
POST A COMMENT