jack3140

LATEST ACTIVITY

• Posted in thread: any kitchen faucet brands to avoid? on 06-21-2008 at 08:45 PM
  after trying various brands i have settled on moen have had nothing but for a long time and
  anytime something has gone wrong i go to to rona and they hand me replacement parts free and no
  questions as...

• Posted in thread: Special Light Switch Required on 02-17-2008 at 06:41 PM
  i would get an inexpensive photo control and install it on the exterior floodlight then you
  could leave the switch on all the time it would take care of itself

• Posted in thread: Adding an electric garage heater on 02-17-2008 at 06:16 PM
  just a little caution here make sure the spaces are on the same side of the panel in order to
  get 240volts

• Posted in thread: GFI Won't Reset on 02-17-2008 at 05:41 PM
  try disconnecting the wire going out from it then reset it if it resets then you have a ground
  fault somewhere if not replace it

• Posted in thread: Any Advise for Tired Cabinets? on 02-17-2008 at 05:28 PM
  they are wood alright you can tell by the grain if you want a real nice job strip them to bare
  wood and restain i think they would come out very nice

• Posted in thread: No power to my thermostat on 02-17-2008 at 05:23 PM
  how are you testing for power? if you try across the thermostat wires you will get nothing
  because it is only a switch connected in series go to the source ie the transfo god luck

• Posted in thread: Mold – Vapor Barrier Question for the Experts. on 02-17-2008 at 05:16 PM
  if i may i think your condensation problem comes from the fact that cold air is hitting the
  wall from the outside causing the moisture inside to condense on the wall . before you
  reinstall the sheatin...

• Posted in thread: One thermostat, two heat sources on 02-17-2008 at 05:04 PM
  i would suggest you use a double pole double throw switch connect the thermostat in the middle
  and the units on each side hope this helps if you need a sketch let me know good luck

• Posted in thread: Ceiling fan switch replacement. on 02-17-2008 at 04:52 PM
  you must have a multiple speed fan with lights yes?

• Posted in thread: Air Compressor Timer on 01-25-2008 at 03:24 PM
  assuming you just want to control the power get a small electronic timer and a 30a 2pole
  contactor feed the power thru the contactor and control the contactor with the timer hope this
  helps