Last Activity:08-26-2015 1:38 PM
Likes Given: 2
96 Likes on 78 Posts
Posted in thread: Green Commercial Buildings on 08-27-2015 at 05:33 PM
It would help if you added your location to your profile.Depending on where you are there may
be local tax credits, power company discounts, state insentives.
Posted in thread: Can plastic push & seal drain be attached to metal p-trap? on 08-24-2015 at 06:31 AM
I would have removed and tossed that old plated pipe and replaced with PVC anyway.Looks like
it's in poor shape, and at some point it always rust out and leaks.A whole new trap assembly
might cost a w...
Posted in thread: New exterior door. This can't be right.... on 08-24-2015 at 06:27 AM
Any prehung door I've ever installed has an 1-1/2 thick threshold.If he did add a 2 X 4 under
it as I think you suggest (but I doubt) it would have been done so the opening could be flashed
on the out...
Posted in thread: Can I pull 110 power from my well pump circuit? on 08-21-2015 at 05:24 PM
Shed should have it's own power source.Left everyone guessing what size wire was run to the
pump house, 120 or 240 volt, what type wire and number of wires.Going to get a whole lot of
questions and a ...
Posted in thread: Keep Old Water Heater? on 08-20-2015 at 05:42 PM
A used water heater is worthless.Only thing that stored water would be good for is is flushing
Posted in thread: Mobile Home shingle roof leak from ridge? on 08-17-2015 at 07:03 AM
If I had of done that job I would have used a ridge vent so the whole roof gets vented.If
there's no soffit vents for make up air any roof venting will not be working the way
should.There is no specia...
Posted in thread: Preferred finish methods for trim on 08-17-2015 at 06:47 AM
Totally depends on what looks good to you.There is just no set "rule".How is the rest of the
house done? I'd want it to match what's already there.
Posted in thread: Private Messaging on 08-09-2015 at 02:19 PM
I'm with frodo on this one.How many new post have we all seen asking where to buy something,
how deep should my plumbing, plumbing, wiring, ECT. be, do I need a permit, how many outlets
can I have on ...
Posted in thread: Question on height of foundation with sonotubes. on 08-04-2015 at 06:51 AM
I'd be using pilings set to below the frost line.Sort of like
Posted in thread: Ceiling sheetrock repair cost on 08-03-2015 at 07:13 AM
Is there insulation above that area or is there a second floor?Should be getting more then just
one price anyway, then you'll know if it's to high.