Kerrylib

LATEST ACTIVITY

• Posted in thread: Kitchen Cabinets on 03-16-2010 at 03:02 PM
  Personal recomendation.I do not care for tile countertops. Current house has 3 bathrooms w/
  tile countertops.Everything you do in the kitchen is going to slop over onto the countertop.
  Any grout lines...

• Posted in thread: LG LRFC22750ST beeps 3 times every 30 seconds on 08-06-2009 at 02:03 PM
  Take a look here for your model #I just found this looking for info about my dryer that is not
  able to start tumbling. Not just owners manuals, but they also have service manuals to download
  as well.G...

• Posted in thread: Refrigerator bottom not cooling, freezer section OK on 08-06-2009 at 01:56 PM
  Frost buildup in the vent/damper/duct between freezer and fridge compartments did that to me
  once.Ended up shutting it down and completely defrosting and drying out freezer compartment and
  clearing ou...

• Posted in thread: Painting Stripes on Bedroom Wall on 02-20-2009 at 03:37 PM
  Two tips."burnish" the edge of the tape by pressing it tight to the wall with the edge of a
  putty knife, or similar tool. Just don't gouge the wall.Lay out your lines w/ faint pencil, or
  perhaps laser...

• Posted in thread: Brush surprise! on 01-26-2009 at 10:04 AM
  Thanks for the heads up. Good to hear about a tool well suited to the job. I've also used
  thinner brushes for cutting in. Your comments about this bigger brush holding more paint make
  sense. I also li...

• Posted in thread: Closet Door Opens, Lights On, Shut door, Light off on 01-20-2009 at 11:37 AM
  What Jay SaidElectric Door Light Switch 600 Watt - Rockler Woodworking Tools

• Posted in thread: A house made of straw on 01-19-2009 at 10:41 AM
  Bale construction I have seen is quite cost effective.What I have seen is essentially a "pole
  barn" type construction, often steel beams. Then the straw bales are bulit up between the
  beams. The bales...

• Posted in thread: Please don't laugh - I'm serious about this question on 01-08-2009 at 01:03 PM
  Be sure to get the good shrink tube that has an adhesive liner in it as well. It will melt when
  you shrink it down and seal tightly to the wire. If you get the plain shrink tube without the
  adhesive i...

• Posted in thread: Never cut a finger off again! on 01-08-2009 at 12:56 PM
  I agree the price tag is a bit much for me as well. However, what is a severed finger/hand
  worth to you?The fact that you have to replace the blade/safety mechanism if it does trip
  stinks, but how muc...

• Posted in thread: Questions about in wall/ ceiling speakers on 01-05-2009 at 03:28 PM
  I have a co-worker who just installed some speakers that are truly hidden speakers. You
  texture, prime, and paint right over them after install.The company is onsia Onsia Concealed
  Sound SolutionsHe s...