VIEW MY

knix98

Gift Premium Subscription To knix98

Join Date:

01-01-2014

Last Activity:

01-25-2014 2:50 PM

Likes Given: 3

LATEST ACTIVITY

  • Posted in thread: 1 Zone not heating on 01-25-2014 at 01:27 PM
    Hi everybody,I have 3 heating zones one of the zones is not getting heat for some reason. The
    oil burner kicks on when I turn on the thermostat but no heat. I did a little research and
    people were sug...

  • Posted in thread: Washer Drain Pipe on 01-05-2014 at 09:39 PM
    Thanks for all the help it is greatly appreciated.

  • Posted in thread: Washer Drain Pipe on 01-05-2014 at 02:50 PM
    To see ahead of time if a vent will work you could snake a tube down the pipe that allows air
    to enter. If no change it's likely a clog.Ok Ill try that. Looks like most places have the vent
    close to s...

  • Posted in thread: Washer Drain Pipe on 01-05-2014 at 12:20 PM
    just looking at exactly that....appears that the vent should be close to the trap.

  • Posted in thread: Washer Drain Pipe on 01-05-2014 at 11:50 AM
    Did some measuring the first pipe is sloped 5 inches over 6ft then the next pipe is sloped 4
    inches over just a little less than 6 ft. The whole thing starts 52 inches off the ground and
    ends inches o...

  • Posted in thread: Washer Drain Pipe on 01-02-2014 at 07:02 PM
    I really don't know anything about plumbing so Im not sure where the stack is or if there is a
    stack. The drain pipe goes into the basement wall which is about 6-8 feet away but uses
    probably 10-12ft ...

  • Posted in thread: Washer Drain Pipe on 01-01-2014 at 03:09 PM
    Hi,My washer drain pipe keeps overflowing. I tried snaking it but a clog does not seem to be
    the problem. I think it may be the setup. If you look at the picture originally the standpipe
    was 9 inches ...

0 COMMENTS
POST A COMMENT