lostpilot28

LATEST ACTIVITY

• Posted in thread: Trane XE 90 pressure switch on 11-01-2012 at 10:08 AM
  Sounds like what I went through. Basically, with the hose connected, the heater would stop
  working...pressure in the upper part of the heater was too high, and the pressure switch would
  (rightfully so...

• Posted in thread: Trane XE 90 pressure switch on 02-16-2012 at 07:14 AM
  Just wanted to post a quick update...I finally got my XE90 fixed. The heat exchanger was
  replaced, because the old one had a huge crack in the plastic interface part where the exhaust
  gas exits. :eek:...

• Posted in thread: Trane XE 90 pressure switch on 01-25-2012 at 06:58 AM
  Well, no. Sorry, I don't believe that for a second...unless you put your furnace outside, or
  very near an opening. My furnace is as far inside my garage as it can go. Not affected by wind
  at all.But, ...

• Posted in thread: Trane XE 90 pressure switch on 10-12-2011 at 08:07 AM
  Well, I wasn't there to hear everything that he said...so I may need to talk to him on the
  phone today. I think a 2nd opinion is in order. I am the 2nd owner of the home, so I think the
  heat exchanger...

• Posted in thread: Trane XE 90 pressure switch on 10-11-2011 at 06:17 PM
  Alright...here's an update. I decided to call my heating repair guy. I wasn't home, but the
  wife was...he apparently looked inside with a borescope camera and told my wife there was a
  crack in the hea...

• Posted in thread: Trane XE 90 pressure switch on 10-10-2011 at 04:28 PM
  Thanks again...I've cleaned the hoses to the pressure switch, and I've verified they're not
  blocked on the header. There is no water sloshing around in the inducer. Any further ideas?

• Posted in thread: Trane XE 90 pressure switch on 10-10-2011 at 03:35 PM
  Thanks for that, HVACTech. I was looking at that thing today, but I didn't see how it could
  have any effect on the pressure switch. Can you elaborate a bit?Update: It took me about 15
  minutes to remov...

• Posted in thread: Trane XE 90 pressure switch on 10-09-2011 at 07:48 PM
  Thanks for that, HVACTech. I was looking at that thing today, but I didn't see how it could
  have any effect on the pressure switch. Can you elaborate a bit?Update: It took me about 15
  minutes to remov...

• Posted in thread: Trane XE 90 pressure switch on 10-09-2011 at 06:18 PM
  Hi everyone, I've been dealing with the same problem for a couple years, but it's getting
  worse. In the past, the unit would cycle a couple times before igniting and providing heat.
  Toward the end of ...