- Posts 13
Last Activity:02-04-2006 9:24 AM
Posted in thread: Need Suggestion on 02-01-2006 at 04:36 PM
Go to HOME DEPOT and talk to the guy in the cabinet department, they carry all you need to
build your diswasher cabinet. Extension, diswasher end base and countertop. Still you need
Posted in thread: low flow faucet on 02-01-2006 at 04:19 PM
Shut off hot water valve and remove supply line. Slowly open valve to test for pressure, if not
pressure, remove valve stem and see what you find wrong there. If pressurized, check supply
Posted in thread: Outside Bathroom floor drain on 01-28-2006 at 04:03 PM
If this new shower is going to be discharging to your actual sewer line, this part must be
connected to a U or trap below the floor. Drain rules may call for all drains to be traped to
avoid gases fro...
Posted in thread: Outside Bathroom floor drain on 01-28-2006 at 03:52 PM
Do you mean outside shower?. The shown PVC drain part look like a 3 inches one, more than
enough for draining your future shower. Make sure it is flushed to the floor and pitch the
floor toward the dr...
Posted in thread: Run out of hot water on 01-19-2006 at 02:43 PM
Why does this happen?....Low capacity water heater tank. Water heater temperature set too low,
allowing you to open hot water side of shower full blast. Rise temperature of water heater or
shut water ...
Posted in thread: Lack of Gas Hot Water on 01-17-2006 at 06:14 PM
May be a crossed line, a cold water line connected to the hot water line. Shut off valve at
water heater and open hot water side from any faucet, if water still continue to run, you have
a crossed lin...
Posted in thread: Stripping and refinishing kitchen cabinets on 01-16-2006 at 10:18 PM
If these cabinets are painted with a lot of coats of paint over, try a heat gun to remove as
much as possible coats of paint and then use the chemical remover to finish the removing steps.
Posted in thread: Desperate Mom needs HELP!! on 01-16-2006 at 10:02 PM
Seek help from your city housing department.
Posted in thread: low flow toilet recommendations on 01-16-2006 at 09:37 PM
Low price? I found good reliability in LAMOSA from home depot.
Posted in thread: Slow draining tub on 01-16-2006 at 09:11 PM
Also check the lowerflow hole, remove scrwed cover. Use a 4 to 5 inches piece of wire with a
1/4 inche folded at the end to remove hairs from these hole. This in addition to the overflow "
- One Word Game
- question about water from central a/c
- deck roof and gutter question
- Possible mold problems??
- A little help with hardware, please?
- Aggressive Deer
- Suggestions on how to repair
- Crumbling, 'spaling' exterior foundation walls
- pressure washer advice
- Toilet will not fill
- Fire Safety
- Attaching wood post to concrete slab
- soffit vent ?
- Driveway Resurfacing
- Lennox A/C isn't cooling