Last Activity:10-16-2010 12:52 PM
Posted in thread: painting wicker furniture on 10-16-2010 at 11:17 AM
I'm no expert, but here's what my grandma would tell you ...- carefully clean off anything
'loose' re your old sealer with a soft brush- apply new oil based wood primer over any areas
that the old sea...
Posted in thread: Help with Paint Disaster! on 10-16-2010 at 10:35 AM
^^^ yeah, agreed re Behr paint and Home Depot personnel ( or Valspar paint and Lowe's
personnel, or Ben Moore paint and Ace Hardware personnel etc.). I recently finished a metal
roof repainting projec...
Posted in thread: hopefully I didn't screw up in repainting a corrugated metal roof on 10-16-2010 at 09:28 AM
Hello everyone. I wish that I had found this forum before embarking on this project, but better
late than never. At any rate, I'm looking for opinions as to whether I screwed up or not during
Posted in thread: Wiring Capacitors for Baldor VL1309 Air Compressor Motor on 10-16-2010 at 08:40 AM
Not pretending to be an expert here, but in the absence of exact specs ...- the run ( main )
winding will always have the higher ohm value- the start ( auxiliary ) winding will always have
the lower o...
- Transistion problem
- Carrier HVAC - Fan not turning
- Tub soft spots
- My cat is a moron, again
- Home improvement
- Re attaching flagstone in walkway
- What's that smell?
- Removing Shower Door/Frame Nails?
- Small hairline cracks in fiberglass balcony
- Tearing up ground level deck to deal with drainage issues at rear of house
- Granite Installed - Possible Issue?
- Floor Drain for AC Condensate Discharge
- Fastening to vinyl siding
- Builder's Joke Thread
- Stainless Steel Fridge
- One Word Game