oldognewtrick

LATEST ACTIVITY

• Posted in thread: moisture from missing singles at roof peak? on 06-19-2013 at 04:39 AM
  Thanks all! I may post again about this but I think I've got it. Appreciate your time and
  wisdom.Give us a follow up when you're done to let us know how it turned out.

• Posted in thread: Need to temporarily remove A/C to replace decking on 06-18-2013 at 07:11 AM
  There is usually enough flex in the lines where moving the unit is USUALLY not a problem. Just
  use care.

• Posted in thread: Need to temporarily remove A/C to replace decking on 06-18-2013 at 06:24 AM
  We roof under units all the time. You just have to be careful when you work around them. Take a
  couple 4x4's and lay the the same direction as your deck boards, then take some 2x's and slide
  under the...

• Posted in thread: This is a Test Thread on 06-17-2013 at 04:00 PM
  Well...I didn't study.....so I'll do my best.:DWell you should of been studying instead of
  making maple syrup.

• Posted in thread: moisture from missing singles at roof peak? on 06-17-2013 at 11:32 AM
  Most houses with trusses have solid blocking between trusses at the peak to support the plywood
  edge, should that be moved down each side to allow for the slot and still support the plywood.
  I've neve...

• Posted in thread: moisture from missing singles at roof peak? on 06-17-2013 at 11:03 AM
  On houses with a ridge beam cut 1-3/4" on each side of the peak. On houses without out a ridge
  beam 1" on either side, stopping at least 6" from the rake edge.

• Posted in thread: Happy Father's Day on 06-17-2013 at 07:21 AM
  Yes, we did have a relaxing day, and the weather was ok too, thank you.:)You've been having a
  lil rain up your way haven't you inspector?

• Posted in thread: moisture from missing singles at roof peak? on 06-17-2013 at 07:19 AM
  As W-O-W said, remove the existing roll ridge vent, then you can check the decking edge for
  possible water issues. Pick up some 4' sections of shingle over ridge vent and a couple bundles
  of matching ...

• Posted in thread: Possible mold problems?? on 06-16-2013 at 01:43 PM
  What type of caulk did you use?

• Posted in thread: Happy Father's Day on 06-16-2013 at 12:10 PM
  Yep, what Eric said. My dads not here anymore so I can't call him up and say thanks for being
  there for me, but I appreciate him just the same.Happy Fathers Day everyone.