oldslowchevy

LATEST ACTIVITY

• Posted in thread: thank papadan on 06-16-2006 at 05:18 PM
  i truely thank you for your responce. but atleast now i know it's not my fault:) but your
  insite will me missed else where:( take care and i will see you on here from time to time.

• Posted in thread: how to block hummmm on 05-15-2006 at 02:05 PM
  ok here is the deal down here in florida atleast where i am every thing is cinder block.i want
  to close in my car port in for addtional living space almost 700 sq feet.but how in the world
  do i fasten...

• Posted in thread: HELP!!! What's that smell??? on 05-14-2006 at 02:42 PM
  mildew can do that witch is why i had to rid of my boat.if i had to guess that MIGHT be the
  source of the problem.

• Posted in thread: stops rust best? on 05-08-2006 at 05:33 AM
  on my table saw i use a good dose of linseed oil the reason i dont use wax like many others is
  where in live here in florida is it is very hot(87 deg at 6 am this morning)and when i cut i
  dont want th...

• Posted in thread: Ten things to remember.... on 05-07-2006 at 08:02 PM
  my wife agrees with 6

• Posted in thread: Fiber Cement Board Siding on 05-07-2006 at 07:35 AM
  i have used the cement siding i don't like it!ok frist yes you should still use the tyvek with
  any type of siding in my opion.the cement siding is is a pain in the neck as in you need a
  daimond blade ...

• Posted in thread: Roofing project online on 05-01-2006 at 04:39 PM
  nice job on the saddle but one thing about it (is code in maryland when i lived in calvert co
  anyway)you should take a small hand head grinder up there and cut a 1/2 in grove into the brick
  and mortar...

• Posted in thread: NewBe - intro - and question on 04-27-2006 at 11:35 AM
  you will have to go to your town hall and find out the exact requirments on the footer i would
  think a footer of 25"deep about a foot wide might be close the deepth in almost allways 6"below
  the frost...

• Posted in thread: Extending J channel or starter strip nail flange higher? Or short screws? on 04-26-2006 at 09:09 AM
  the easy way i have dealt with this was to rip down a 2x4 to the right size.once the wood is
  installed,break a piece of metal to wrap aroundthe t-111 under the bottom and up the back side
  of the new w...

• Posted in thread: Where is everybody? on 04-25-2006 at 07:31 AM
  welcome to this forum and look forword to hearing from you and your posts'question and your
  answers